IMP, Lanzhou
Advancement of nuclear physics and high power heavy ion accelerator is always a driving force for persistent development of highly charged ECR ion source. Increasing demands for more intense and higher charge state heavy ion beams have dramatically promoted development of ECR ion source technology and physics. This talk provides an overview of intense highly charged superconducting ECR ion sources built by the world-wide laboratories in the last years. The key technologies, challenges and main issues related to construction and operation of high performance superconducting ECR ion source are reviewed. The latest results of intense highly charged ion beam production from the superconducting ECR ion sources are presented. Future development and the next generation highly charged ECR ion source are discussed.
RCNP, Osaka
An upgrade program of the RCNP cyclotron facility for increase of beam intensity and improvement of beam quality is in progress to meet requirements from research in nuclear physics and industrial applications using secondarily produced particles such as neutrons, muons and radioisotopes. A 2.45 GHz ECR ion source using a set of permanent magnets was developed for high intensity proton beam production. The proton beam intensity more than 0.5 mA at an extraction energy of 15 keV has been obtained with a proton ratio more than 80 %. The quality of the pre-accelerated beam from the K140 injector AVF cyclotron has been improved by a flat-top(FT) acceleration system to enhance the beam transmission to the K400 ring cyclotron. Transversal resonant mode of a dee electrode with a span angle of 180 degrees was investigated to achieve the FT acceleration in the frequency region from 50 to 60 MHz. In this paper, developments for high intensity proton beam acceleration and beam quality improvement using the FT acceleration system of the AVF cyclotron will be mainly presented.
Kyoto ICR, Uji, Kyoto
We aim to develop a small and high intensity proton source for a compact accelerator based neutron source. Because this proton source shall be located close to RFQ for simplification, ratio of H+ to molecular ions such as H2+ or H3+ must be large. Therefore, we selected an ECR ion source with permanent magnets as small and high intensity ion source. ECR ion sources can provide high H+ ratio because of their high plasma temperature. Using permanent magnets makes the ion source small and running cost low. Because there is no hot cathode, longer MTBF is expected. Usually, gas is fed into ion sources continuously, even if ion sources run in pulse operation mode. But, continuous gas flow doesn't make vacuum in good level. So, we decided to install pulse gas valve directly to the plasma chamber. Feeding the gas only when the ion source is in operation reduces the gas load to the evacuation system and the vacuum level can be kept high. Up to now, we developed the first and second model of the ion source. And the research is being conducted using the second model. Recent experimental results will be presented.
PKU/IHIP, Beijing
A compact remote control system with the SIMATIC S7-300 PLC is being designed for Peking University Neutron Imaging FaciliTY (PKUNIFTY). PKUNIFTY consists of a 2.45GHz ECR Deuteron ion source, LEBT, a 201.5MHz RFQ cavity, HEBT and Be target. Now PLC control system for ECR ion source and LEBT has been completed and tested. This paper will present the structure of the control system, the HMI with useful data recording system, and some measures took to improve the system safety.
JLAB, Newport News, Virginia
The College of William and Mary, Williamsburg
ODU, Norfolk, Virginia
NSU, Newport News
In the past years, energetic vacuum deposition methods have been developed in different laboratories to improve Nb/Cu technology for superconducting cavities. Jefferson Lab and collaborators are pursuing energetic condensation deposition via Electron Cyclotron Resonance. As part of this study, the influence of the deposition energy, the coating temperature and the substrate's nature on the material and RF properties of the Nb thin film is investigated. The film surface and structure analyzes are conducted with various techniques like X-ray diffraction, Transmission Electron Microscopy, Auger Electron Spectroscopy and RHEED. The microwave properties of the films are characterized on 50 mm disk samples with a 7.5 GHz surface impedance characterization system. This paper presents surface impedance measurements in correlation with surface and material characterization for Nb films produced on various substrates with different bias voltages. Emerging opportunities for developing multi-layer superconducting rf films are also highlighted with the commissioning results of a new deposition system.
RCNP, Osaka
The upgrade program of the AVF cyclotron is in progress since 2004 at Research Center for Nuclear Physics (RCNP), Osaka Univ., for improving the quality, stability and intensity of accelerated beams. An 18 GHz superconducting ECRIS has been installed to increase beam currents and to extend the variety of ions, especially for highly charged heavy ions which can be accelerated by RCNP cyclotrons. The production development of several ion like B, C ~ Xe by gas mixing or MIVOC has been performed. In order to extend the variety of ions more, metal viper or spatter system has also been installed to 10GHz NEOMAFIOS with minimum modifications. The details of these recent developments will be presented.
RIKEN Nishina Center, Wako
SHI Accelerator Service Ltd., Tokyo
The next generation heavy ion accelerator facility, such as the RIKEN RIBF, requires great variety of high charged heavy ions with a magnitude higher beam intensity than currently achievable. In the last decade, performance of the ECR ion sources has been dramatically improved with increasing the magnetic field and RF frequency to enhance the density and confinement time of plasma. Furthermore, the effects of the key components (magnetic field configuration, gas pressure etc) on the ECR plasma have been revealed. Such basic studies give us how to optimize the ion source structure. Based on these studies and the technology, we successfully constructed the new 28GHz SC-ECRIS which has a flexible magnetic field configuration to enlarge the ECR zone and to optimize the field gradient at ECR point. In the test experiment, we obtained the direct evidence that the field gradient and the zone size strongly affect the beam intensity. It concludes that the gentler field gradient and large ECR zone size gives intense beam of highly charged heavy ions from ECR plasma. In this contribution, we report the systematic study of these effects on the beam intensity of highly charged heavy ions.