Paper | Title | Other Keywords | Page |
---|---|---|---|
TUB02 | NICA Collider Magnetic Field Correction System | collider, quadrupole, FEM, dipole | 41 |
|
|||
The NICA Collider is a new superconducting facility that has two storage rings, each of about 503 m in circumference, which is under construction at the Joint Institute for Nuclear Research, Dubna, Russia. The influence of the fringe fields and misalignments of the lattice magnets, the field imperfections and natural chromaticity should be corrected by the magnetic field correction system. The layout and technical specification of the magnetic field correction system, the main parameters, arrangements and the field calculations and measurement results of the corrector magnets are presented. The results of dynamic aperture calculation at working energies are shown. | |||
![]() |
Slides TUB02 [2.299 MB] | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUB02 | ||
About • | Received ※ 07 October 2021 — Accepted ※ 09 October 2021 — Issued ※ 17 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
TUPSB10 | Modeling of the Spin-Navigator Method for Manipulating the Beam Polarization in a Spin-Transparent Storage Ring | polarization, storage-ring, closed-orbit, injection | 251 |
|
|||
A method for manipulating the orientation of the beam polarization axis based on using the so-called "spin-navigator" technique in a storage ring operating in the spin-transparent regime has been modelled. The beam particles’ spin- and orbital dynamics have been numerically investigated with the purpose of determining the method’s feasibility; the latter’s effect on spin-decoherence has been studied also. | |||
![]() |
Poster TUPSB10 [1.848 MB] | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB10 | ||
About • | Received ※ 24 September 2021 — Accepted ※ 29 September 2021 — Issued ※ 06 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
TUPSB11 | Numerical Investigation of the Robustness of Spin-Navigator Polarization Control Method in a Spin-Transparent Storage Ring | polarization, detector, solenoid, controls | 254 |
|
|||
The robustness of spin-navigator based method for manipulating the beam polarization axis has been investigated with respect to bend magnet installation errors. Toward that end, variation of the invariant spin axis components along the beamline of an imperfect storage ring operating in the spin-transparent mode has been estimated. The beam polarization vector behavior in the given lattice has been investigated. Conclusions are made regarding the feasibility of using spin navigator solenoids for defining the beam polarization axis in the detector region. | |||
![]() |
Poster TUPSB11 [0.536 MB] | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB11 | ||
About • | Received ※ 12 September 2021 — Revised ※ 13 September 2021 — Accepted ※ 20 September 2021 — Issued ※ 11 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
TUPSB26 | Lattice Options With Reverse Bending Magnets for USSR HMBA Storage Ring | SRF, synchrotron, emittance, storage-ring | 280 |
|
|||
The 4th generation light source, the Ultimate Source of Synchrotron Radiation (USSR) is under design, to be built in Moscow region (Russia). It will be a 6 GeV and about 1100 m circumference storage ring synchrotron. Baseline lattice of the USSR for now is a scaled version of the ESRF-EBS Hybrid Multi-Bend Achromat (HMBA) lattice that was successfully commissioned in 2020. Its natural horizontal electron beam emittance is about 70 pm·rad. Further reduction of beam emittance can be achieved with the use of reverse bending magnets. The evolution of the envisaged lattices for the USSR storage ring, including options with reverse bends will be presented. | |||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB26 | ||
About • | Received ※ 24 September 2021 — Revised ※ 25 September 2021 — Accepted ※ 29 September 2021 — Issued ※ 18 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
TUPSB33 | 2.5 GeV Booster Synchrotron for a New Kurchatov Synchrotron Radiation Source | booster, synchrotron, electron, storage-ring | 293 |
|
|||
The Project of complete modernization of the current accelerator complex is in progress in the NRC «Kurchatov Institute». A new booster synchrotron is a part of the injection complex for a new 3-d generation synchrotron light source. The booster has to ensure reliable and stable operation of the upgraded main storage ring. The paper presents the final design of the new booster synchrotron and its main parameters. | |||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB33 | ||
About • | Received ※ 22 September 2021 — Accepted ※ 23 September 2021 — Issued ※ 16 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
TUPSB34 | New Lattice Design for Kurchatov Synchrotron Radiation Source | synchrotron, radiation, synchrotron-radiation, ion-source | 297 |
|
|||
Funding: The reported study was partially funded by RFBR, project number 19-29-12039 Nowadays the upgrade project of the 2nd generation synchrotron radiation source operating at NRC Kurchatov Institute has been ongoing. The main aim of the project is to create a new synchrotron radiation source with the same 124 m circumference and providing synchrotron radiation properties inherent to the 3rd generation sources (emittance ~ 3 nm·rad). The new machine will consist of new storage ring with 2.5 GeV electron energy, full energy booster synchrotron and 0.2 GeV linac. The mandatory requirement for the project is to keep all currently operating beamlines. In this article we present the design challenges and approaches for this machine, the conceptional design and baseline lattice. |
|||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB34 | ||
About • | Received ※ 22 September 2021 — Revised ※ 29 September 2021 — Accepted ※ 09 October 2021 — Issued ※ 20 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||
WED04 | Precise Analysis of Beam Optics at the VEPP-4M by Turn-by-Turn Betatron Phase Advance Measurement | optics, collider, betatron, experiment | 79 |
|
|||
Turn-by-turn (TbT) beam centroid signals can be used to evaluate various relevant accelerator parameters including betatron frequencies and optical functions. Accurate estimation of parameters and corresponding variances are important to drive accelerator lattice correction. Signals acquired from beam position monitors (BPMs) are limited by beam decoherence and BPM resolution. Therefore, it is important to obtain accurate estimations from available data. Several methods based on harmonic analysis of TbT data are compared and applied to the VEPP-4M experimental signals. The accuracy of betatron frequency, amplitude, and phase measurements are investigated. Optical functions obtained from amplitudes and phases are compared. | |||
![]() |
Slides WED04 [3.771 MB] | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-WED04 | ||
About • | Received ※ 12 September 2021 — Revised ※ 20 September 2021 — Accepted ※ 23 September 2021 — Issued ※ 20 October 2021 | ||
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | ||