TUXGBF —  MC5 Orals   (01-May-18   09:00—10:30)
Chair: M.G. Minty, BNL, Upton, Long Island, New York, USA
Paper Title Page
TUXGBF1
XFEL Impedance Effects and Mitigation  
 
  • M. Dohlus
    DESY, Hamburg, Germany
 
  A detailed impedance budget has been set up for the European XFEL, including the contributions from 2000 components, such as 824 cavities, 500 flanges, 220 BPMs (5 types, 78 pumps, 20 OTR screens, 7 collimators, 5 BAMs, 3 kickers, warm pipe etc. Both surface effects and geometric effects are important. Bunch compression and warm beam pipe require additional consideration. Most important are possible beam degradation affecting the FEL operation. Longitudinal wake fields lead to energy losses and unwanted energy spread. Even with mitigation, the wake-induced energy loss are larger than the energy losses due to the FEL lasing process. Various technical solutions have been developed to minimize the effects. This invited talk presents the basis for these simulations, their results, and comparisons with recent beam measurements in the European XFEL.  
slides icon Slides TUXGBF1 [2.070 MB]  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
TUXGBF2 Higher-Order-Mode Effects in Tesla-Type Superconducting RF Cavities on Electron Beam Quality 612
 
  • A.H. Lumpkin, N. Eddy, D.R. Edstrom, P.S. Prieto, J. Ruan, R.M. Thurman-Keup
    Fermilab, Batavia, Illinois, USA
  • K. Bishofberger, B.E. Carlsten
    LANL, Los Alamos, New Mexico, USA
  • O. Napoly
    CEA/DSM/IRFU, France
 
  Funding: *Work at Fermilab supported by FRA, LLC under Contract No. DE-AC02-07CH11359 with the U.S. Dept. of Energy. **Work at LANL supported by U.S. Dept. of Energy through the LANL/LDRD Program.
We report the direct observations of the correlation of higher order modes (HOMs) generated by off-axis electron beam steering in TESLA-type SCRF cavities and sub-macropulse beam centroid shifts (with the concomitant effect on averaged beam size and emittance). The experiments were performed at the Fermilab Accelerator Science and Technology (FAST) facility using its unique configuration of a PC rf gun injecting beam into two separated 9-cell cavities in series with corrector magnets and beam position monitors (BPMs) located before, between, and after them. The ~100-kHz oscillations with up to 300-μm amplitudes at downstream locations were observed in a 3-MHz micropulse repetition rate beam with charges of 500 and 1000 pC/b, although the effects were much reduced at 100 pC/b. The studies were based on HOM detector circuitry targeting the first and second dipole passbands, rf BPM bunch-by-bunch data, and imaging cameras viewing multi-slit images for emittance assessments at 33 MeV. Initial calculations reproduced a key feature of the phenomena. In principle, these results may be scaled to cryomodule configurations of major accelerator facilities.
 
slides icon Slides TUXGBF2 [3.631 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUXGBF2  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
TUXGBF3 Reduction of the Kicker Impedance Maintaining the Performance of Present Kicker Magnet at RCS in J-PARC 616
 
  • Y. Shobuda, Y. Irie, T. Takayanagi, T. Togashi, K. Yamamoto, M. Yamamoto
    JAEA/J-PARC, Tokai-Mura, Naka-Gun, Ibaraki-Ken, Japan
 
  The present kicker at RCS in J-PARC is designed to make a waveform by superposing the forward and backward currents from the power source to extract beams, so that one terminal of the kicker is shorted and the other one is open. On the other hand, the kicker impedance is the dominant source of the beam instability at the RCS. This report proposes a scheme to reduce the kicker impedance, maintaining the beneficial of the superposition of currents with the present kicker magnet.  
slides icon Slides TUXGBF3 [9.947 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUXGBF3  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
TUXGBF4 ORBIT Simulation, Measurement and Mitigation of Transverse Beam Instability in the Presence of Strong Space Charge in the 3-GeV RCS of J-PARC 620
 
  • P.K. Saha, H. Harada, N. Hayashi, H. Hotchi, Y. Shobuda, F. Tamura
    JAEA/J-PARC, Tokai-Mura, Naka-Gun, Ibaraki-Ken, Japan
 
  The transverse impedance of eight extraction pulse kicker magnets (KM) is extremely strong source of transverse beam instability in the 3-GeV RCS (Rapid Cycling Synchrotron) at J-PARC. To realize the designed 1 MW beam power, collective beam dynamics with including the space charge effect for the coupled bunch instabilities excited by the KM impedance and associated measures were studied by incorporating all realistic time-dependent machine parameters in the ORBIT 3-D particle tracking code. The simulation results were all reproduced by measurements and, as a consequence, an acceleration of 1 MW beam power has been successfully demonstrated. In order to maintain variation of the RCS parameters required for multi-user operation, realistic measures for beam instability mitigation were proposed and also been successfully implemented in reality. To further increase the RCS beam power, beam stability issues and possible measures beyond 1 MW beam power are also considered.  
slides icon Slides TUXGBF4 [2.241 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-TUXGBF4  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)