Paper |
Title |
Other Keywords |
Page |
TUPP036 |
Performance of an In-Air Secondary Emission Grid Profile Monitor at the ISIS Neutron and Muon Source |
target, simulation, data-acquisition, neutron |
407 |
|
- D.W. Posthuma de Boer, C. Bovo, H.V. Cavanagh, B. Jones, A.H. Kershaw, A. Pertica
STFC/RAL/ISIS, Chilton, Didcot, Oxon, United Kingdom
|
|
|
The ISIS neutron and muon source, located in the UK, consists of an H− linear accelerator, a rapid cycling proton synchrotron and extraction lines to two target stations. A project is currently under way to replace the target assembly of the First Target Station (TS1) in order to secure its continued operation and improve operational flexibility. In addition to a number of other diagnostic tools, a new secondary emission (SEM) grid profile monitor is expected to be located within the helium atmosphere of the new target assembly. To investigate the performance of an out-of-vacuum SEM grid, a prototype monitor was positioned in-air between a beam exit window and a dump. Profile measurements taken with this monitor are presented, including tests at a range of bias voltages with a fast data acquisition system to investigate secondary signal sources.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IBIC2019-TUPP036
|
|
About • |
paper received ※ 04 September 2019 paper accepted ※ 07 September 2019 issue date ※ 10 November 2019 |
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|
WEPP033 |
Position Based Phase Scan |
cavity, MEBT, alignment, quadrupole |
605 |
|
- N. Milas, M. Eshraqi, Y. Levinsen, R. Miyamoto, D.C. Plostinar
ESS, Lund, Sweden
- Y. Liu
KEK/JAEA, Ibaraki-Ken, Japan
|
|
|
Knowledge of the longitudinal beam parameters is important for understanding beam dynamics in linacs. As well as with transverse optics, the settings for the RF cavities have to be established and phase and amplitude seen by the beam must be determined in order to guarantee a stable motion in the longitudinal plane. This work presents an extension of the most widely used phase scan method, relying on time-of-flight, using only transverse positions measured at a few selected BPMs downstream of the cavity being scanned. In principle, the method can be applied both to normal conducting and SC. The suggested method is fast and relatively simple and is capable to provide the values for the cavity transverse misalignment (offsets and tilts) at the same time. It can be a useful part of the initial longitudinal beam tuning.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IBIC2019-WEPP033
|
|
About • |
paper received ※ 04 September 2019 paper accepted ※ 10 September 2019 issue date ※ 10 November 2019 |
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|