SRF2013 - List of Authors (Forel, S.)

Paper	Title	Page
TUP047	Niobium Cavity Electropolishing Modelling and Optimisation	518
	L.M.A. Ferreira, S. Calatroni, S. Forel CERN, Geneva, Switzerland J.A. Shirra Loughborough University, Leicestershre, United Kingdom
	It’s widely accepted that electropolishing is the most suitable surface finishing process to achieve high performance bulk Nb accelerating cavities. At CERN, as part of the R&D studies for the 704 MHz high-beta SPL cavities, a new vertical electropolishing facility has been assembled and a study is on-going for the modelling of electropolishing on cavities with COMSOL software. In a first phase, the electrochemical parameters were taken into account for a fixed process temperature and flow rate, and are presented in this poster as well as the results obtained on a real SPL single cell cavity. The procedure to acquire the data used as input for the simulation is presented. The modelling procedure adopted to optimise the cathode geometry, aimed at a uniform current density distribution in the cavity cell for the minimum working potential and total current is explained. Some preliminary results on fluid dynamics and Joule effect are also briefly described.

Paper

Title

Page

Niobium Cavity Electropolishing Modelling and Optimisation

518

L.M.A. Ferreira, S. Calatroni, S. Forel
CERN, Geneva, Switzerland
J.A. Shirra
Loughborough University, Leicestershre, United Kingdom

It’s widely accepted that electropolishing is the most suitable surface finishing process to achieve high performance bulk Nb accelerating cavities. At CERN, as part of the R&D studies for the 704 MHz high-beta SPL cavities, a new vertical electropolishing facility has been assembled and a study is on-going for the modelling of electropolishing on cavities with COMSOL software. In a first phase, the electrochemical parameters were taken into account for a fixed process temperature and flow rate, and are presented in this poster as well as the results obtained on a real SPL single cell cavity. The procedure to acquire the data used as input for the simulation is presented. The modelling procedure adopted to optimise the cathode geometry, aimed at a uniform current density distribution in the cavity cell for the minimum working potential and total current is explained. Some preliminary results on fluid dynamics and Joule effect are also briefly described.