A   B   C   D   E   F   G   H   I   K   L   M   N   O   P   Q   R   S   T   U   V   W  

RF-structure

Paper Title Other Keywords Page
WE5PFP053 Design of Superconducting Parallel Bar Deflecting and Crabbing RF Structures cavity, HOM, damping, simulation 2120
 
  • J.R. Delayen, H. Wang
    JLAB, Newport News, Virginia
  • J.R. Delayen
    ODU, Norfolk, Virginia
 
 

Funding: Authored by Jefferson Science Associates, LLC under U.S. DOE Contract No. DE-AC05-06OR23177


A new concept for a deflecting and crabbing rf structure based on half-wave resonant lines was introduced recently*. It offers significant advantages to existing designs and, because of it compactness, allows low frequency operation. This concept has been further refined and optimized for superconducting implementation. Results of this optimization and application to a 400 MHz crabbing cavity and a 499 MHz deflecting cavity are presented.


*A New TEM-Type Deflecting and Crabbing RF Structure, J. R. Delayen and H. Wang, Proc. LINAC08

 
TH5PFP086 About Non Resonant Perturbation Field Measurement in Standing Wave Cavities cavity, resonance, simulation, brilliance 3407
 
  • A. Mostacci, R. Da Re, L. Palumbo
    Rome University La Sapienza, Roma
  • D. Alesini, L. Ficcadenti, B. Spataro
    INFN/LNF, Frascati (Roma)
 
 

We discuss the use of non resonant bead pull technique for measuring fields in standing wave accelerating structures. From the Steele perturbation theory, one can derive the relation between the magnitude and phase of the field in the cavity and the complex reflection coefficient. The effect of the bead size, the calibration of the bead and the comparison with the more common resonant techniques are addressed. As an example, we discuss the measurement on a X-band bi-periodic cavity proposed for linearizing emittance at the Frascati photo-injector SPARC.

 
FR5PFP047 Thermal Control of the Fermi@Elettra Accelerating Sections controls, cavity, simulation, linac 4414
 
  • C. Serpico, G. D'Auria, P. Delgiusto
    ELETTRA, Basovizza
 
 

Funding: "The work was supported in part by the Italian Ministry of University and Research under grant FIRB-RBAP045JF2 or grant FIRB-RBAP06AWK3 or grants FIRB-RBAP045JF2 and FIRB-RBAP06AWK3"


FERMI@Elettra is a FEL user facility under construction at Sincrotrone Trieste, Italy. It will use the existing normal conducting S-band Linac and seven accelerating sections received from CERN after the LIL decommissioning. Two additional new sections are also foreseen. The Linac repetition rate will be 10 Hz during the initial stage of operation, but it will be ramped up from 10 Hz to 50 Hz. Due to the higher RF power dissipation, the temperature distribution on the copper structure will reach higher values. RF heating will imply a thermal deformation of the accelerating cavities, both in the transversal and in the longitudinal direction. Since FERMI@Elettra has stringent requirements on phase stability, the length of the section must be kept as constant as possible. In this paper the thermo-mechanic behaviour of the accelerating sections is investigated and the results of the simulations are presented. Furthermore an algorithm has been developed to control the longitudinal deformation of the sections.