| Paper | Title | Page |
|---|---|---|
| RPAP044 | Linearizing the Response of the NSRL Synchronous Recycling-Integrators | 2830 |
|
||
|
Funding: Work performed under the auspices of the U.S. Department of Energy. The LBNL designed recycling-integrators used for the NSRL dosimetry feature excellent linearity. However, switching transients in the balancing source add a duty-cycle dependence to the response that manifests as a non-linearity near mid-scale and a slope-change above mid-scale. The onset of this non-linearity limits the typical usable dynamic range. Measurements during a recent run showed that at higher intensities the recycling-integrators would operate in the non-linear region enough to exceed the desired tolerance and over count the dose. This report will show how a FPGA, which implements the scalars, was used to compensate the non-linearity allowing higher dose-rates by effectively doubling the dynamic range of the dosimetry system. |
||
| TPAP043 | Electron Cooling of RHIC | 2741 |
|
||
|
We report progress on the R&D program for electron-cooling of the Relativistic Heavy Ion Collider (RHIC). This electron cooler is designed to cool 100 GeV/nucleon at storage energy using 54 MeV electrons. The electron source will be a superconducting RF photocathode gun. The accelerator will be a superconducting energy recovery linac. The frequency of the accelerator is set at 703.75 MHz. The maximum electron bunch frequency is 9.38 MHz, with bunch charge of 20 nC. The R&D program has the following components: The photoinjector and its photocathode, the superconducting linac cavity, start-to-end beam dynamics with magnetized electrons, electron cooling calculations including benchmarking experiments and development of a large superconducting solenoid. The photoinjector and linac cavity are being incorporated into an energy recovery linac aimed at demonstrating ampere class current at about 20 MeV. A Zeroth Order Design Report is in an advanced draft state, and can be found on the web at http://www.agsrhichome.bnl.gov/eCool/.
Under contract with the U.S. Department of Energy, Contract Number DE-AC02-98CH10886. |
||
| TPAT093 | Operations and Performance of RHIC as a Cu-Cu Collider | 4281 |
|
||
|
Funding: Work performed under the auspices of the U.S. Department of Energy. The 5th year of RHIC operations, started in November 2004 and expected to last till June 2005, consists of a physics run with Cu-Cu collisions at 100 GeV/u followed by one with polarized protons at 100 GeV. We will address here overall performance of the RHIC complex used for the first time as a Cu-Cu collider, and compare it with previous operational experience with Au, PP and asymmetric d-Au collisions. We will also discuss operational improvements, such as a ?* squeeze to 85cm in the high luminosity interaction regions from the design value of 1m, system improvements and machine performance limitations, such as vacuum pressure rise, intra-beam scattering, and beam beam interaction. |
||
| RPAT028 | RHIC BPM System Modifications and Performance | 2021 |
|
||
|
Funding: Work performed under the auspices of the U.S. Department of Energy. The RHIC beam position monitor (BPM) system provides independent average orbit and turn-by-turn (TBT) position measurements. In each ring, there are 162 measurement locations per plane (horizontal and vertical) for a total of 648 BPM planes in the RHIC machine. During 2003 and 2004 shutdowns, BPM processing electronics were moved from the RHIC tunnel to controls alcoves to reduce radiation impact, and the analog signal paths of several dozen modules were modified to eliminate gain-switching relays and improve signal stability. This paper presents results of improved system performance, including stability for interaction region and sextupole beam-based alignment efforts. We also summarize performance of improved million-turn TBT acquisition channels for nonlinear dynamics and echo studies. |
||
| RPPE009 | Extremely High Current, High-Brightness Energy Recovery Linac | 1150 |
|
||
|
Funding: Under contract with the U.S. Department of Energy, U.S. DOD Office of Naval Research and Joint Technology Office. Next generation ERL light-sources, high-energy electron coolers, high-power Free-Electron Lasers, powerful Compton X-ray sources and many other accelerators were made possible by the emerging technology of high-power, high-brightness electron beams. In order to get the anticipated performance level of ampere-class currents, many technological barriers are yet to be broken. BNL’s Collider-Accelerator Department is pursuing some of these technologies for its electron cooling of RHIC application, as well as a possible future electron-hadron collider. We will describe work on CW, high-current and high-brightness electron beams. This will include a description of a superconducting, laser-photocathode RF gun and an accelerator cavity capable of producing low emittance (about 1 micron rms normalized) one nano-Coulomb bunches at currents of the order of one ampere average. |
||
| RPPT032 | High Current Energy Recovery Linac at BNL | 2242 |
|
||
|
Funding: Work performed under Contract Number DE-AC02-98CH10886 with the auspices of the U.S. Department of Energy. We present the design and the parameters of a small Energy Recovery Linac (ERL) facility, which is under construction at BNL. This R&D facility has goals to demonstrate CW operation of ERL with average beam current in the range of 0.1 - 1 ampere, combined with very high efficiency of energy recovery. The possibility for future up-grade to a two-pass ERL is being considered. The heart of the facility is a 5-cell 703.75 MHz super-conducting RF linac with HOM damping. Flexible lattice of ERL provides a test-bed for testing issues of transverse and longitudinal instabilities and diagnostics of intense CW e-beam. We present the status and plans for this facility. |