A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Pivi, M.T.F.

Paper Title Page
TPPT044 Beam Position Monitoring Using the HOM-Signals from a Damped and Detuned Accelerating Structure 2804
 
  • S. Doebert, C. Adolphsen, R.M. Jones, J.R. Lewandowski, Z. Li, M.T.F. Pivi, J.W. Wang
    SLAC, Menlo Park, California
  • T. Higo
    KEK, Ibaraki
 
  Funding: Work Supported by DOE Contract DE-AC02-76F00515.

The Next Linear Collider (NLC) and Global Linear Collider (GLC) designs require precision beam-to-accelerator-structure alignment to reduce the effect of short range wakefields. For this purpose, the HOM signals from the structure dipole mode damping ports would be used to determine the beam position in the structure, and then the structures would be moved remotely to center them about the beam (a 5 micron rms alignment is required). In 2000, a test of a 1.8 m prototype structure in the ASSET facility at SLAC achieved 11 micron rms centering accuracy, which was limited by systematic effects caused by beam jitter. This year, such measurements were repeated for a pair of shorter structures (60 cm) that were developed to improve high gradient performance. In addition, the beam position resolution was determined by measuring simultaneously three signal frequencies (14.3, 15, 15.7 GHz) corresponding to modes localized at the beginning, the middle and the end of the structures. In this paper, we present results from the beam centering and position resolution measurements.

 
ROPB001 Suppressing Electron Cloud in Future Linear Colliders 24
 
  • M.T.F. Pivi, R.E. Kirby, T.O. Raubenheimer
    SLAC, Menlo Park, California
  • F. Le Pimpec
    PSI, Villigen
 
  Funding: Work supported by the U.S. DOE under contract DE-AC02- 76SF00515.

Any accelerator circulating positively charged beams can suffer from a build-up of an electron cloud in the beam pipe. The cloud develops through ionization of residual gases, synchrotron radiation and secondary electron emission and, when severe, can cause instability, emittance blow-up or loss of the circulating beam. The electron cloud is potentially a limiting effect for both the Large Hadron Collider (LHC) and the International Linear Collider (ILC). For the ILC positron damping ring, the development of the electron cloud must be suppressed. This paper presents the various effects of the electron cloud and evaluates their significance. It also discusses the state-of-the-art of the ongoing international R&D program to study potential remedies to reduce the secondary electron yield to acceptably low levels.

 
RPPP038 Electron-Cloud Effects in Transport Lines of a Normal Conducting Linear Collider 2527
 
  • J. Wu, M.T.F. Pivi, T.O. Raubenheimer, A. Seryi
    SLAC, Menlo Park, California
 
  Funding: Work is supported by the U.S. Department of Energy under contract DE-AC02-76SF00515.

In the transport lines of a normal conducting linear collider, the long positron bunch train can generate an electron cloud which can then amplify intra-train offsets. This is a transient effect which is similar to but different from the electron-cloud driven coupled bunch instabilities in a positron storage ring. In this paper, we study this phenomenon both analytically and via numerical simulation. Some criterion on the critical cloud density with respect to given collider parameters is discussed.

 
RPPP045 Single-Bunch Instability Driven by the Electron Cloud Effect in the Positron Damping Ring of the International Linear Collider 2884
 
  • M.T.F. Pivi, T.O. Raubenheimer
    SLAC, Menlo Park, California
  • A.F. Ghalam
    USC, Los Angeles, California
  • K.C. Harkay
    ANL, Argonne, Illinois
  • K. Ohmi
    KEK, Ibaraki
  • R. Wanzenberg
    DESY, Hamburg
  • A. Wolski
    LBNL, Berkeley, California
  • F. Zimmermann
    CERN, Geneva
 
  Funding: Work supported by the U.S. DOE under contracts DE-AC02-76SF00515.

With the recommendation that the future International Linear Collider (ILC) should be based on superconducting technology, there is considerable interest in exploring alternate designs for the damping rings (DR). The TESLA design was 17 km in circumference with a "dog-bone" configuration. Two other smaller designs have been proposed that are 6 km and 3 km in length. In the smaller rings, collective effects may impose the main limitations. In particular for the positron damping ring, an electron cloud may be produced by ionization of residual gas or photoelectrons and increase through the secondary emission process. The build-up and development of an electron cloud is more severe with the higher average beam current in the shorter designs. In this paper, we present recent computer simulation results for the electron cloud build-up and instability thresholds for the various DR configurations.

 
FPAP001 Electron Cloud Build-Up Study for DAFNE 779
 
  • C. Vaccarezza, R. Cimino, A. Drago, M. Zobov
    INFN/LNF, Frascati (Roma)
  • G. Bellodi
    CCLRC/RAL/ASTeC, Chilton, Didcot, Oxon
  • K. Ohmi
    KEK, Ibaraki
  • M.T.F. Pivi
    SLAC, Menlo Park, California
  • G. Rumolo
    GSI, Darmstadt
  • D. Schulte, F. Zimmermann
    CERN, Geneva
 
  After the first experimental observations compatible with the presence of the electron cloud effect in the DAFNE positron ring, a more systematic study has been performed regarding the e-cloud build-up and related instability. The measured field map of the magnetic field has been taken into account in the simulation for elements present in the four 10 m long bending sections, representing 40% of the whole positron ring. The simulation results obtained with different codes are presented and compared with the recent experimental observations performed on the beam instabilities and the vacuum behavior of the positron ring.  
RPPP003 Proposal of the Next Incarnation of Accelerator Test Facility at KEK for the International Linear Collider 874
 
  • H. Hayano, S. Araki, H. Hayano, Y. Higashi, Y. Honda, K.-I. Kanazawa, K. Kubo, T. Kume, M. Kuriki, S. Kuroda, M. Masuzawa, T. Naito, T. Okugi, R. Sugahara, T. Tauchi, N. Terunuma, N. Toge, J.U. Urakawa, V.V. Vogel, H. Yamaoka, K. Yokoya
    KEK, Ibaraki
  • I.V. Agapov, G.A. Blair, G.E. Boorman, J. Carter, C.D. Driouichi, M.T. Price
    Royal Holloway, University of London, Surrey
  • D.A.-K. Angal-Kalinin, R. Appleby, J.K. Jones, A. Kalinin
    CCLRC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • P. Bambade
    LAL, Orsay
  • K.L.F. Bane, A. Brachmann, T.M. Himel, T.W. Markiewicz, J. Nelson, N. Phinney, M.T.F. Pivi, T.O. Raubenheimer, M.C. Ross, R.E. Ruland, A. Seryi, C.M. Spencer, P. Tenenbaum, M. Woodley
    SLAC, Menlo Park, California
  • S.T. Boogert, A. Liapine, S. Malton
    UCL, London
  • H.-H. Braun, D. Schulte, F. Zimmermann
    CERN, Geneva
  • P. Burrows, G.B. Christian, S. Molloy, G.R. White
    Queen Mary University of London, London
  • J.Y. Choi, J.Y. Huang, H.-S. Kang, E.-S. Kim, S.H. Kim, I.S. Ko
    PAL, Pohang, Kyungbuk
  • S. Danagoulian
    North Carolina A&T State University, Greensboro, North Carolina
  • N. Delerue, D.F. Howell, A. Reichold, D. Urner
    OXFORDphysics, Oxford, Oxon
  • J. Gao, W. Liu, G. Pei, J.Q. Wang
    IHEP Beijing, Beijing
  • B.I. Grishanov, P.L. Logachev, F.V. Podgorny, V.I. Telnov
    BINP SB RAS, Novosibirsk
  • J.G. Gronberg
    LLNL, Livermore, California
  • Y. Iwashita, T. Mihara
    Kyoto ICR, Uji, Kyoto
  • M. Kumada
    NIRS, Chiba-shi
  • S. Mtingwa
    North Carolina University, Chapel Hill, North Carolina
  • O. Napoly, J. Payet
    CEA/DSM/DAPNIA, Gif-sur-Yvette
  • T.S. Sanuki, T.S. Suehara
    University of Tokyo, Tokyo
  • T. Takahashi
    Hiroshima University, Higashi-Hiroshima
  • E.T. Torrence
    University of Oregon, Eugene, Oregon
  • N.J. Walker
    DESY, Hamburg
 
  The realization of the International Linear Collider (ILC) will require the ability to create and reliably maintain nanometer size beams. The ATF damping ring is the unique facility where ILC emittancies are possible. In this paper we present and evaluate the proposal to create a final focus facility at the ATF which, using compact final focus optics and an ILC-like bunch train, would be capable of achieving 35nm beam size. Such a facility would enable the development of beam diagnostics and tuning methods, as well as the training of young accelerator physicists.