A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Lee, H.-S.

Paper Title Page
WPAE015 High Heat-Load Slits for the PLS Multipole Wiggler 1449
 
  • K.H. Gil, J.Y. Choi, C.W. Chung, Y.-C. Kim, H.-S. Lee
    PAL, Pohang, Kyungbuk
 
  The HFMX (High Flux Macromolecular X-ray crystallography) beamline under commissioning at Pohang Accelerator Laboratory uses beam from a multipole wiggler for MAD experiment. Two horizontal and vertical slits relevant to high heat load are installed at its front-end. In order to treat high heat load and to reduce beam scattering, the horizontal slit has two glidcop blocks with 10° of vertical inclination and its tungsten blades defining beam size are bolted on backsides of both blocks. The blocks of the slit are adjusted on fixed slides by two actuating bars, respectively. Water through channels machined along the actuating bars cool down the heat load of both blocks. The vertical slit has the same structure as the horizontal slit except its installation direction and angle of vertical inclination. The installed slits show stable operation performance and no alignment for the blocks is required by virtue of a pair of blocks translating on slides. The cooling performance of two slits is also shown to be acceptable. In this article, the details of the design and manufacture of the two slits are presented and its operation performance is reported.  
WPAE016 Development of a Precision Amplifier for the Detector 1514
 
  • K.-H. Park, C.W. Chung, S.-M. Hong, S.-H. Jeong, Y.G. Jung, D.E. Kim, H.-S. Lee, W.W. Lee
    PAL, Pohang, Kyungbuk
  • B.-K. Kang
    POSTECH, Pohang, Kyungbuk
 
  A high gain trans-resistance amplfier has been developed for measuring the intensity of synchrotron radiation at Pohang Light Source(PLS). This amplifier built with discrete elements and operational amplifiers.It had the capability of measuring range from 1pA to 1 uA with good linearity. A microprocessor was also installed to interface the amplifier with the computer, and controlled the other sub-circuits. The various characteristics of amplifier such as linearity, sensitivity,stability, etc. have been investigated, and its experimental results carried out at the beam line are presented in this paper.