A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Guerra, AA.

Paper Title Page
WPAT034 The CEBAF Separator Cavity Resonance Control System 2339
 
  • M.J. Wissmann, AA. Guerra, C. Hovater, T. Plawski
    Jefferson Lab, Newport News, Virginia
 
  Funding: This work supported by the U.S. Department of Energy under contract DE-AC05-84ER40150.

The CEBAF energy upgrade from 6 GeV to 12GeV will increase the range of beam energies available to the experimental halls. RF deflection cavities (separators) are used to direct the electron beam to the three experimental halls. Consequently with the increase in RF separator cavity gradient needed for the higher energies, RF power will also increase requiring the cavities to have active resonance control. At the 6 GeV energy, the cavities are tuned mechanically and then stabilized with Low Conductivity Water (LCW), which is maintained at constant temperature of 95o Fahrenheit. This is no longer feasible and an active resonance control system, that controls both water temperature and flow has been built. The system uses a commercial PLC with embedded PID controls to control water temperature and flow to the cavities. The system allows the operator to remotely adjust temperature/flow and consequently cavity resonance for the full range of beam energies. Ultimately closed loop control will be maintained by monitoring the cavities reflected power. This paper describes this system.