| Paper | Title | Page |
|---|---|---|
| RPAT070 | Mechanical and Thermal Design of the CEBAF Hall A Beam Calorimeter | 3819 |
|
||
|
Funding: DOE. A calorimeter has been proposed to provide 0.5% - 1.0% absolute measurements of beam current in the Hall A end station of the Thomas Jefferson National Accelerator Facility (JLab) CEBAF machine. Silver and copper calorimeters built in the 1960’s achieved precisions of about 1%. Modern powder metallurgy processes have produced high density, high thermal conductivity tungsten-copper composite materials that will minimize beam loss while maintaining a rapid thermal response time. Heat leaks will be minimized by mounting the mass in vacuum on glass ceramic mounts. A conduction cooling scheme utilizes an advanced carbon fiber compliant thermal interface material. Transient finite difference and finite element models were developed to estimate heat leaks and thermal response times. |
||
| RPAT100 | Radiation-Hard Beam Position Detector for Use in the Accelerator Dump Lines | 4341 |
|
||
|
Funding: This work supported by the U.S. Department of Energy under contract DE-AC05-84ER40150 The new proposed method of beam position measurement is particularly suitable for monitoring high energy, and high power accelerated beams of charged particles in the vicinity of power beam dumps. Generally, the beam quality in those areas is very poor, and any equipment positioned there must be extremely resistant to radiation damage. We have found that a plate made of Chemical Vapor Deposition (CVD) Silicon Carbide (SiC) has a set of physical properties that make it suitable for such an application. CVD SiC material is a chemically inert, extremely radiation-hard, thermo-resistive semiconductor capable of withstanding working temperatures up to 2000 degrees Kelvin. It has good thermal conductivity comparable to that of Aluminum, which makes it possible to use it in high-current particle beams. High electrical resistivity of the material, and its semiconductor properties allow characterization of the position of a particle beam crossing such a plate by measuring balance of electrical currents at the plate ends. The design of a test device, and first results are presented in the report. |