A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Decking, W.

Paper Title Page
WOAC008 Measuring and Understanding the Momentum Aperture in a Storage Ring 645
 
  • C. Steier, D. Robin
    LBNL, Berkeley, California
  • W. Decking
    DESY, Hamburg
  • J. Laskar
    IMCCE, Paris
  • L.S.N. Nadolski
    SOLEIL, Gif-sur-Yvette
  • Y.K. Wu
    DU/FEL, Durham, North Carolina
  
  Funding: This work was supported by the U.S. Department of Energy, under Contract No. DE-AC03-76SF00098.

The momentum aperture of a storage ring is a very important parameter that strongly influences the performance, especially the beam lifetime. For the special case of synchrotron light sources with small emittance like the Advanced Light Source (ALS), the momentum aperture depends strongly on the transverse dynamics. It is very sensitive to machine conditions such as the tunes, chromaticities, lattice symmetry, and spurious coupling, since depending on those conditions the Touschek scattered particles explore different resonance regions in the phase space. In light sources, the momentum aperture usually also depends strongly on the vertical physical aperture. Applying frequency analysis techniques in simulations and for turn-by-turn orbit measurement data provides a very powerful tool to measure and understand limitations of the dynamic momentum aperture. The techniques presented are applicable to other light sources, as well as damping rings and many types of colliders.

 
RPAE036 Damping Wigglers for the PETRA III Light Source 2446
 
  • M. Tischer, K. Balewski, W. Decking, M. Seidel, L. Yongjun
    DESY, Hamburg
  • V. Kuzminykh, E. Levichev, P. Vobly, K. Zolotariov
    BINP SB RAS, Novosibirsk
  
  Within the reconstruction of the PETRA booster ring at DESY towards a third generation light source after 2007, damping wigglers will be installed to reduce the emittance to a value of 1 nmrad. Two damping sections in the long straights of PETRA have been assigned to accommodate 20 wigglers in total. The wigglers will be permanent magnet devices with a fixed gap which are surrounded by an iron enclosure to reduce the leakage flux. Each wiggler will provide a damping integral of 4 T2m per segment and generate a synchrotron radiation power of 42 kW. A short one period long prototype has recently been built to prove the magnetic design and study the correction scheme for tuning the pole strength. The wiggler segments will be followed by an SR absorber shading the downstream quadrupole and successive wiggler segment, the accumulated on-axis power of about 200 kW will be taken up by the final absorber at the damping section end.  
RPPT011 Optimized Bunch Compression System for the European XFEL 1236
 
  • T. Limberg, V. Balandin, R. Brinkmann, W. Decking, M. Dohlus, K. Floettmann, N. Golubeva, Y. Kim, E. Schneidmiller
    DESY, Hamburg
  
  The European XFEL bunch compressor system has been optimized for greater flexibility in parameter space. Operation beyond the XFEL design parameters is discussed in two directions: achieving the uppermost number of photons in a single pulse on one hand and reaching the necessary peak current for lasing with a pulse as short as possible on the other. Results of start-to-end calculations including 3D-CSR effects, space charge forces and the impact on wake fields demonstrate the potential of the XFEL for further improvement or, respectively, its safety margin for operation at design values.