• V. Bharadwaj, Y.K. Batygin, R. Pitthan, D.C. Schultz, J. Sheppard, H. Vincke, J.W. Wang
  SLAC, Menlo Park, California
• J.G. Gronberg, W. Stein
  LLNL, Livermore, California

A positron source for the ILC can be designed using either a multi-GeV electron beam or a multi-MeV photon beam impinging on a metal target. The major issues are: the drive beam, choice of target material, the design of the target station, the capture section, the target vault, and beam transport to the damping ring. In this paper, positron source parameters for the various schemes are outlined and the advantages and disadvantages of each scheme are discussed.

• V. Bharadwaj, R. Pitthan, J. Sheppard, H. Vincke, J.W. Wang
  SLAC, Menlo Park, California

In an ILC positron source, multi-GeV electrons or multi-MeV photons impinge on a metal target. In either case, the incoming beam power is hundreds of kilowatts. Various computer programs - such as FLUKA or MARS – can calculate how the incoming beam showers in the target and can track the particle showers through the positron source system. The incoming energy ends up as heat in the various positron source elements. This paper presents results from such calculations and their impact on the design of a positron source for the ILC.

• J.W. Wang, C. Adolphsen, V. Bharadwaj, G.B. Bowden, V.A. Dolgashev, R.M. Jones, E.N. Jongewaard, J.R. Lewandowski, Z. Li, R.H. Miller
  SLAC, Menlo Park, California

There are many challenges in the design of the normal-conducting portion of ILC positron injector system such as achieving adequate cooling with the high rf and particle loss heating, and sustaining high accelerator gradients during millisecond-long pulses in a strong magnetic field. The proposed design for the positron injector contains both standing-wave and traveling-wave L-band accelerator structures for high RF efficiency, low cost and ease of fabrication. This paper presents results from studies of particle energy deposition for both undulator based and conventional positron sources, cooling system design, accelerator structure optimization, RF pulse heating, cavity frequency stabilization, and RF feed system design.