Fermilab, Batavia, Illinois, USA
Muons, Inc, Illinois, USA
SLAC, Menlo Park, California, USA
BNL, Upton, Long Island, New York, USA
LBNL, Berkeley, California, USA
UMiss, University, Mississippi, USA
The Muon Accelerator Program has completed a four-year study on the feasibility of muon colliders and on using stored muon beams for neutrinos. That study was broadly successful in its goals, establishing the feasibility of lepton colliders from the 125 GeV Higgs Factory to more than 10 TeV, as well as exploring using μ storage rings for neutrinos. The key components of the muon collider scenarios are a high-intensity proton source, a multi MW target and transport system for π capture, a front end system for bunching, energy compression and initial cooling of μ's, muon cooling systems to obtain intense μ+ and μ- bunches, acceleration up to multiTeV energies, and a collider ring with detectors for high luminosity collisions. For a neutrino factory a similar system could be used but with a racetrack storage ring for ν production and without the cooling needed for high luminosity collisions. Feasible designs and detailed simulations of all of these components have been obtained, including some initial hardware component tests, setting the stage for future implementation where resources are available and clearly associated physics goals become apparent.
UMiss, University, Mississippi, USA
Fermilab, Batavia, Illinois, USA
Fermilab, Batavia, Illinois, USA
UMiss, University, Mississippi, USA
IIT, Chicago, Illinois, USA
Illinois Institute of Technology, Chicago, Illinois, USA
Emittance exchange mediated by wedge absorbers is required for longitudinal ionization cooling and for final transverse emittance minimization for a muon collider. A wedge absorber within the MICE beam line could serve as a demonstration of the type of emittance exchange needed for 6-D cooling, including the configurations needed for muon colliders. Parameters for this test are explored in simulation and possible experimental configurations with simulated results are presented.
IIT, Chicago, Illinois, USA
Fermilab, Batavia, Illinois, USA
STFC/RAL/ASTeC, Chilton, Didcot, Oxon, United Kingdom
Illinois Institute of Technology, Chicago, Illinois, USA
Cooled muon beams are essential to enable future Neutrino Factory and Muon Collider facilities. The international Muon Ionization Cooling Experiment (MICE) aims to demonstrate muon beam cooling through ionization energy loss in material. A figure of merit for muon beam cooling in MICE is the transverse root-mean-square (RMS) emittance reduction and to measure this, the individual muon positions and momenta are reconstructed using two scintillating-fiber tracking detectors housed in spectrometer solenoid modules. The reconstructed positions and momenta before and after a low-Z absorbing material are then used for constructing the covariance matrix and measuring normalized transverse RMS emittance of MICE muon beam. However, RMS emittance is sensitive to nonlinear effects in beam optics. In this study, the direct measurement of phase-space density as an alternative approach to measuring the muon beam cooling using the novel Kernel Density Estimation (KDE) method, is described.
