Author: Raparia, D.
Paper Title Page
MOPO100 Doubly Stripped Proton Causing Vacuum Leak at Brookhaven 200 MeV H− linac Complex 214
 
  • D. Raparia, G. Atoian, T. Lehn, V. LoDestro, M. Mapes, A. McNerney, J. Ritter, A. Zelenski
    BNL, Upton, Long Island, New York, USA
  
  Doubly stripped H− in the low energy beam transport are capture 180 degree apart in the RF of RFQ and accelerated to the full energies. These protons are bend in the opposite direction of H− after the 200 MeV drift tube linac and caused vacuum leak. A new beam dump for these stripped protons is planned  
poster icon Poster MOPO100 [4.781 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-MOPO100  
About • paper received ※ 11 September 2018       paper accepted ※ 20 September 2018       issue date ※ 18 January 2019  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
THPO117
 96Zr Beam Acceleration for Isobar Experiment in RHIC  
THOP12   use link to see paper's listing under its alternate paper code  
 
  • M. Okamura, E.N. Beebe, S. Ikeda, T. Kanesue, D. Raparia
    BNL, Upton, Long Island, New York, USA
  • H. Haba
    RIKEN Nishina Center, Wako, Japan
  
  Funding: This manuscript has been authored by Brookhaven Science Associates, LLC under Contract No. DE-SC0012704 with the U.S. Department of Energy.
To investigate chiral magnetic effect, 96Zr and 96Ru beams have been accelerated at relativistic heavy ion collider (RHIC) in Run18 at Brookhaven National Laboratory (BNL). 96Zr and 96Ru beams were provided from electron beam ion source (EBIS) injector and tandem Van de Graaff, repectively. In the presentation, 96zr beam production and acceleration will be reported. The EBIS injector consist of laser ion source, EBIS as a charge breeder, 300 keV/u RFQ and 2 MeV/u IH-DTL. The natural abundance of 96Zr is only 2.8 % and about 50 % is occupied by 90Zr. To obtain sufficient beam current, mass number 96 enriched material was used. Unfortunately, only available form of the enriched material is oxide powder which does not suit for laser ion source target. We have established sintering technique of ZrO2 powder to make a solid piece which can be installed into the laser ion source. The induced singly charged Zr and oxygen were delivered to the EBIS to be ionized further. We have optimized laser irradiation condition, EBIS confinement time, operating condition of the linacs to maximized the performance of the linac based injector. The detailed R&D works will be presented in the conference. 		 
slides icon Slides THPO117 [2.920 MB]  
poster icon Poster THPO117 [4.167 MB]  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)