LINAC2018 - List of Authors (Gerhard, P.)

Paper	Title	Page
TU2A03	Layout of the New FAIR Post-stripper DTL for Intense Heavy Ion Beams	303
	S. Mickat, X. Du, P. Gerhard, L. Groening, M. Heilmann, M. Kaiser, A. Rubin, V. Srinivasan, W. Sturm GSI, Darmstadt, Germany
	The new post-stripper DTL at GSI shall accelerate uranium beams with space charge induced tune depressions of up to 37% to 11.4 MeV/u. Emittance dilution must be kept below few percent. However, the layout must also allow for delivery of lightest ions to just 3.0 MeV/u. This broad-banded range of requirements imposes huge challenges on the layout and fabrication especially of the cavities and drift tube magnets.
	Slides TU2A03 [4.777 MB]
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-TU2A03
About •	paper received ※ 12 September 2018 paper accepted ※ 21 September 2018 issue date ※ 18 January 2019
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

FR1A05	Development of Pulsed Gas Strippers for Intense Beams of Heavy and Intermediate Mass Ions	982
	P. Gerhard, W.A. Barth, M. Bevcic, Ch.E. Düllmann, L. Groening, K.P. Horn, E. Jäger, J. Khuyagbaatar, J. Krier, M.T. Maier, P. Scharrer, A. Yakushev GSI, Darmstadt, Germany W.A. Barth, Ch.E. Düllmann, J. Khuyagbaatar HIM, Mainz, Germany Ch.E. Düllmann Johannes Gutenberg University Mainz, Institut of Nuclear Chemistry, Mainz, Germany
	The GSI UNILAC together with SIS18 will serve as injector for the future FAIR. A modified 1.4~MeV/u gas stripper setup has been developed, aiming at an increased yield into the particular desired charge state. The setup delivers short pulses of high gas density in synchronization with the beam pulse. This provides a higher gas density. Different gases as stripping targets were tested. Measurements with various isotopes and gas densities were conducted to investigate the stripping properties. High intensity beams of ²³⁸U⁴⁺ were successfully stripped using hydrogen as stripping gas. The stripping efficiency was significantly increased while the beam quality remained suitable. The new stripper setup and major results achieved during the development are presented. Problems with the fast valves arose while they were used for a longer duration. Another revision of the setup took place to exchange the valves. In parallel, the installation of the required infrastructure for regular operation of the gas stripper using hydrogen was planned.
	Slides FR1A05 [10.013 MB]
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-FR1A05
About •	paper received ※ 12 September 2018 paper accepted ※ 20 September 2018 issue date ※ 18 January 2019
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Layout of the New FAIR Post-stripper DTL for Intense Heavy Ion Beams

303

S. Mickat, X. Du, P. Gerhard, L. Groening, M. Heilmann, M. Kaiser, A. Rubin, V. Srinivasan, W. Sturm
GSI, Darmstadt, Germany

The new post-stripper DTL at GSI shall accelerate uranium beams with space charge induced tune depressions of up to 37% to 11.4 MeV/u. Emittance dilution must be kept below few percent. However, the layout must also allow for delivery of lightest ions to just 3.0 MeV/u. This broad-banded range of requirements imposes huge challenges on the layout and fabrication especially of the cavities and drift tube magnets.

Slides TU2A03 [4.777 MB]

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-TU2A03

About •

paper received ※ 12 September 2018 paper accepted ※ 21 September 2018 issue date ※ 18 January 2019

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

FR1A05

Development of Pulsed Gas Strippers for Intense Beams of Heavy and Intermediate Mass Ions

982

P. Gerhard, W.A. Barth, M. Bevcic, Ch.E. Düllmann, L. Groening, K.P. Horn, E. Jäger, J. Khuyagbaatar, J. Krier, M.T. Maier, P. Scharrer, A. Yakushev
GSI, Darmstadt, Germany
W.A. Barth, Ch.E. Düllmann, J. Khuyagbaatar
HIM, Mainz, Germany
Ch.E. Düllmann
Johannes Gutenberg University Mainz, Institut of Nuclear Chemistry, Mainz, Germany

The GSI UNILAC together with SIS18 will serve as injector for the future FAIR. A modified 1.4~MeV/u gas stripper setup has been developed, aiming at an increased yield into the particular desired charge state. The setup delivers short pulses of high gas density in synchronization with the beam pulse. This provides a higher gas density. Different gases as stripping targets were tested. Measurements with various isotopes and gas densities were conducted to investigate the stripping properties. High intensity beams of ²³⁸U⁴⁺ were successfully stripped using hydrogen as stripping gas. The stripping efficiency was significantly increased while the beam quality remained suitable. The new stripper setup and major results achieved during the development are presented. Problems with the fast valves arose while they were used for a longer duration. Another revision of the setup took place to exchange the valves. In parallel, the installation of the required infrastructure for regular operation of the gas stripper using hydrogen was planned.

Slides FR1A05 [10.013 MB]

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-FR1A05

About •

paper received ※ 12 September 2018 paper accepted ※ 20 September 2018 issue date ※ 18 January 2019

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)