JACoW logo

Joint Accelerator Conferences Website

The Joint Accelerator Conferences Website (JACoW) is an international collaboration that publishes the proceedings of accelerator conferences held around the world.


RIS citation export for THPRB034: Timing Synchronization System for Beam Injection from the SACLA Linac to the SPring-8 Storage Ring

TY  - CONF
AU  - Ohshima, T.
AU  - Hosoda, N.
AU  - Maesaka, H.
AU  - Matsubara, S.
ED  - Boland, Mark
ED  - Tanaka, Hitoshi
ED  - Button, David
ED  - Dowd, Rohan
ED  - Schaa, Volker RW
ED  - Tan, Eugene
TI  - Timing Synchronization System for Beam Injection from the SACLA Linac to the SPring-8 Storage Ring
J2  - Proc. of IPAC2019, Melbourne, Australia, 19-24 May 2019
CY  - Melbourne, Australia
T2  - International Particle Accelerator Conference
T3  - 10
LA  - english
AB  - We developed a timing synchronization system for beam injections from the linac of the X-ray free-electron laser (XFEL), SACLA, to the current SPring-8 storage ring. This injection scheme is beneficial for the next upgraded ring, SPring-8-II, where low emittance injection beams is required. The developed timing system aims at synchronizing the timing between the RF frequencies of the two accelerators which do not have a common subharmonic frequency. An important point is to keep the high performance of the current timing system which provides stable XFEL operation at SACLA. For this purpose, we designed and constructed a MicroTCA.4 system comprised of a high-speed ADC and an RF front-end for the synchronization. The RF signal of SACLA is digitized by the ADC whose clock is synchronized to SPring-8. A digital down-converter in the FPGA on the ADC module gives the phase difference instantaneously and a feedback logic applies a frequency modulation (FM) to the master oscillator of SACLA so as to synchronize SACLA with SPring-8. A bench test result showed that the timing jitter between the two frequency at injection timing was 1.2 ps rms, which was sufficient for the required value of 3 ps rms for the beam injection to the ring. In this presentation, we report an overview of the synchronization system, details of the developed electronics and the system performance obtained by a beam injection experiment from SACLA to SPring-8.
PB  - JACoW Publishing
CP  - Geneva, Switzerland
SP  - 3882
EP  - 3885
KW  - timing
KW  - linac
KW  - injection
KW  - storage-ring
KW  - laser
DA  - 2019/06
PY  - 2019
SN  - 978-3-95450-208-0
DO  - DOI: 10.18429/JACoW-IPAC2019-THPRB034
UR  - http://jacow.org/ipac2019/papers/thprb034.pdf
ER  -