JACoW logo

Joint Accelerator Conferences Website

The Joint Accelerator Conferences Website (JACoW) is an international collaboration that publishes the proceedings of accelerator conferences held around the world.

RIS citation export for SUSPFO024: Advanced Beam Dynamics Design for the Superconducting Heavy Ion Accelerator HELIAC

AU  - Schwarz, M.
AU  - Aulenbacher, K.
AU  - Barth, W.A.
AU  - Basten, M.
AU  - Burandt, C.
AU  - Busch, M.
AU  - Conrad, T.
AU  - Dziuba, F.D.
AU  - Gettmann, V.
AU  - Heilmann, M.
AU  - Kürzeder, T.
AU  - Lauber, S.
AU  - List, J.
AU  - Miski-Oglu, M.
AU  - Podlech, H.
AU  - Rubin, A.
AU  - Yaramyshev, S.
ED  - Boland, Mark
ED  - Tanaka, Hitoshi
ED  - Button, David
ED  - Dowd, Rohan
ED  - Schaa, Volker RW
ED  - Tan, Eugene
TI  - Advanced Beam Dynamics Design for the Superconducting Heavy Ion Accelerator HELIAC
J2  - Proc. of IPAC2019, Melbourne, Australia, 19-24 May 2019
CY  - Melbourne, Australia
T2  - International Particle Accelerator Conference
T3  - 10
LA  - english
AB  - The standalone superconducting (SC) continuous wave (CW) heavy ion linac HELIAC (HElmholtz LInear ACcelerator) is a common project of GSI and HIM under key support of IAP Frankfurt and in collaboration with Moscow Engineering Physics Institute (MEPhI) and Moscow Institute for Theoretical and Experimental Physics (KI-ITEP). It is intended for future experiments with heavy ions near the Coulomb barrier within super-heavy element (SHE) research and aims at developing a linac with multiple CH cavities as key components downstream the High Charge State Injector (HLI) at GSI. The design is challenging due to the requirement of intense beams in CW mode up to a mass-to-charge ratio of 6, while covering a broad output energy range from 3.5 to 7.3 MeV/u with minimum energy spread. In 2017 the first superconducting section of the linac has been successfully commissioned and extensively tested with beam at GSI. In the light of experience gained in this research so far, the beam dynamics layout for the entire linac has recently been updated and optimized with particular emphasis on realistic assumptions of cavity gap and drift lengths as well as gap voltage distributions for CH3’CH11.
PB  - JACoW Publishing
CP  - Geneva, Switzerland
SP  - 928
EP  - 931
DA  - 2019/06
PY  - 2019
SN  - 978-3-95450-208-0
DO  - DOI: 10.18429/JACoW-IPAC2019-MOPTS034
UR  - http://jacow.org/ipac2019/papers/mopts034.pdf
ER  -