The Joint Accelerator Conferences Website (JACoW) is an international collaboration that publishes the proceedings of accelerator conferences held around the world.
TY - CONF AU - Hsiung, G.-Y. AU - Chen, J.-R. AU - Cheng, C.M. AU - Hsu, S-N. AU - Hsueh, H.P. AU - Yang, Y.C. ED - Koscielniak, Shane ED - Satogata, Todd ED - Schaa, Volker RW ED - Thomson, Jana TI - Development of the Aluminum Beam Duct for the Ultra-Low Emittance Light Source J2 - Proc. of IPAC2018, Vancouver, BC, Canada, April 29-May 4, 2018 C1 - Vancouver, BC, Canada T2 - International Particle Accelerator Conference T3 - 9 LA - english AB - The future light source with ultra-low emittance, typically < 500 pm rad, requests the beam duct with inner aperture < 20 mm for the electron storage ring. Besides, the cross section of the beam duct must be kept smooth for lowering the impedance. The aluminum extruded beam duct of 10 mm inside and 1 ~ 2 m in length was developed for this purpose. The beam duct was machined in ethanol to obtain a clean surface for a lower thermal outgassing rate. To mitigate the impedance of the flange connection, a special designed diamond-edge gasket and the aluminum flange without knife edge were developed. The inner diameters of both flange and gasket, 10 mm, are the same as that of beam duct. The sealing of the gasket has been proved leak-tight. The ultimate pressure and the thermal outgassing rate of the beam duct has achieved < 2.0·10⁻¹⁰ Torr and < 1.4·10⁻¹³ Torr l/(s cm²), respectively after baking. Those results fulfill both the ultrahigh vacuum and lowest impedance are applicable for the next generation ultra-low emittance light source. PB - JACoW Publishing CP - Geneva, Switzerland SP - 3775 EP - 3777 KW - vacuum KW - experiment KW - storage-ring KW - impedance KW - emittance DA - 2018/06 PY - 2018 SN - 978-3-95450-184-7 DO - 10.18429/JACoW-IPAC2018-THPAL057 UR - http://jacow.org/ipac2018/papers/thpal057.pdf ER -