The Joint Accelerator Conferences Website (JACoW) is an international collaboration that publishes the proceedings of accelerator conferences held around the world.
TY - CONF AU - Vega Cid, L. AU - Abánades, A. AU - Barnes, M.J. AU - Ducimetière, L. AU - Moester, M.T. AU - Vlachodimitropoulos, V. AU - Weterings, W.J.M. ED - Koscielniak, Shane ED - Satogata, Todd ED - Schaa, Volker RW ED - Thomson, Jana TI - Preliminary Design of a Cooling System for the LHC Injection Kicker Magnets J2 - Proc. of IPAC2018, Vancouver, BC, Canada, April 29-May 4, 2018 C1 - Vancouver, BC, Canada T2 - International Particle Accelerator Conference T3 - 9 LA - english AB - The CERN Large Hadron Collider (LHC) is equipped with two fast pulsed magnet systems (MKIs) that inject particle beams from the injector chain. Future operation for High Luminosity LHC (HL-LHC) with high intensity beams will cause heating of the ferrite yokes of the MKIs beyond their Curie temperature, preventing injection until the yokes cool down. Beam coupling impedance studies show that it is possible to move a substantial portion of the beam induced power deposition from the upstream ferrite yokes, which are the yokes with the highest power deposition, to ferrite rings located at the upstream end of the magnet. Thermal predictions show that this power redistribution, combined with the installation of a cooling system around the rings, will maintain the temperatures of all the yokes and ferrite rings below their Curie point. Since the rings are not pulsed to high voltage, whereas the ferrite yokes are, the installation of a cooling system is feasible around the rings. The proposed design of the cooling system will be tested to ensure good performance before its installation on the MKIs. The details of the simulations and the design process are reported. PB - JACoW Publishing CP - Geneva, Switzerland SP - 2624 EP - 2627 DA - 2018/06 PY - 2018 SN - 978-3-95450-184-7 DO - 10.18429/JACoW-IPAC2018-WEPMK001 UR - http://jacow.org/ipac2018/papers/wepmk001.pdf ER -