The Joint Accelerator Conferences Website (JACoW) is an international collaboration that publishes the proceedings of accelerator conferences held around the world.
TY - CONF AU - Cardelli, F. AU - Alesini, D. AU - Magi, M. AU - Palumbo, L. AU - Pellegrino, F. AU - Pettinacci, V. ED - Schaa, Volker RW ED - Petit-Jean-Genaz, Christine ED - Ko, In Soo ED - Kim, Dong Eon ED - Kim, Kyung Sook TI - Design of Linac with the New Gaskets Clamping Fabrication Technique J2 - Proc. of IPAC2016, Busan, Korea, May 8-13, 2016 C1 - Busan, Korea T2 - International Particle Accelerator Conference T3 - 7 LA - english AB - Recently, a new technique for the realization of high gradient accelerating structures based on the use of gaskets without brazing processes, has been successfully tested at high power on a 1.6 cells RF gun (D. Alesini, et al, PRST 18, 02001, 2015). The new technique developed at the Laboratories of Frascati of the INFN (Italy) in the framework of the SPARC_LAB project has been also adopted for the ELI-NP RF gun. The use of the special gaskets that simultaneously guarantee the vacuum seal and a perfect RF contact allow to avoid the brazing process, strongly reducing the cost, the realization time and the risk of failure. Moreover, without copper annealing due to the brazing process, it is possible, in principle, to decrease the breakdown rate increasing, at the same time, the maximum achievable gradient. The extension of this new fabrication process to complex LINAC structures is the next step on the application of this new technique on particle accelerator. In the paper, we discuss how to extend this process to S-band and C-band Travelling Wave accelerating structures illustrating their electromagnetic design and their mechanical realization. PB - JACoW CP - Geneva, Switzerland SP - 403 EP - 406 DA - 2016/06 PY - 2016 SN - 978-3-95450-147-2 DO - 10.18429/JACoW-IPAC2016-MOPMW005 UR - http://jacow.org/ipac2016/papers/mopmw005.pdf ER -