Differential Current Transformer for Beam Charge Monitoring in Noisy Environments
304
H. Maesaka, T. Inagaki
RIKEN SPring-8 Center, Hyogo, Japan
H. Dewa, T. Inagaki, H. Maesaka, K. Yanagida
JASRI, Hyogo, Japan
K. Ueshima
QST, Sendai, Miyagi, Japan
We developed a differential current transformer (CT) for electron beam charge measurement in noisy environments, such as near high-power pulse sources. This CT has four pickup wires coiled at equal intervals (90 deg.) on a toroidal core and each coil is wound for two turns. The midpoint of the coil is connected to the body ground so that a balanced differential signal is generated at both ends. A beam pipe with a ceramics insulation gap is inserted into the toroidal core to obtain a signal from a charged-particle beam. The four pairs of signals are transmitted through a CAT6 differential cable and fed into differential amplifiers. The common-mode noise from the noisy ground at the CT is canceled out by the amplifier. The four signals are then summed and digitized by an AD converter. We produced differential CTs and installed them into the new injector linac of NewSUBARU (*). Before the installation, the frequency response was measured in a laboratory and a flat response of up to 100 MHz was obtained as expected. Common-mode noise cancellation was also confirmed at NewSUBARU and the CTs have been utilized for beam charge monitoring stably. *: T. Inagaki et al., ’Construction of a Compact Electron Injector Using a Gridded RF Thermionic Gun and a C-Band Accelerator’, in Proc. IPAC’21, pp. 2687-2689. doi:10.18429/JACoW-IPAC2021-WEPAB039
Adaptive Feedforward Control of Closed Orbit Distortion Caused by Fast Helicity-Switching Undulators
374
M. Masaki, H. Dewa, T. Fujita, H. Maesaka, K. Soutome, T. Sugimoto, S. Takano, M.T. Takeuchi, T. Watanabe
JASRI, Hyogo, Japan
T. Fukui, H. Maesaka
RIKEN SPring-8 Center, Innovative Light Sources Division, Hyogo, Japan
K. Kubota
SES, Hyogo-pref., Japan
K. Soutome, T. Sugimoto, S. Takano, H. Tanaka, T. Watanabe
RIKEN SPring-8 Center, Hyogo, Japan
We developed a new correction algorithm for closed orbit distortion (COD) based on adaptive feedforward control (AFC). The AFC system effectively works for the suppression of the fast COD due to known error sources with repetitive patterns such as helicity-switching undulators. The scheme aims to counteract error sources by feedforward correctors at the position or in the vicinity of error sources so that a potential risk of unwanted local orbit bumps, which is known to exist for the global orbit feedback, can be eliminated in a reliable and accurate manner. This option is especially advantageous when an error source causes an angular distortion of photon beams such as a fast orbit distortion near undulators. Thus, the AFC provides a complementary capability to a so-called fast global orbit feedback (FOFB) for coming next-generation light sources where ultimate light source stability is essentially demanded. In this talk, introduction to the AFC, its theoretical aspect and advantages, the system overview, the experimental results for the effects of AFC will be presented. M. Masaki, et al., J. Synchrotron Rad. 28, 1758-1768 (2021).
please see instructions how to view/control embeded videos
