| Paper | 
        Title | 
        Page | 
    
    
        | PS16 | 
        The fast head-tail instability suppression in multibunch mode at VEPP-4M
         | 
        138 | 
    
    
        |   | 
        
                - G. Karpov, V. Kiselev, V. Smaluk, N. Zinvich
 
                       BINP, Budker Institute of Nuclear Physics, Novosibirsk, Russia 
          | 
          | 
    
        
            |   | 
            
            In this paper the bunch-by-bunch transverse feedback
            system for suppression fast head-tail as well as coupled
            bunch instabilities is described. The experimental results
            of the feedback affecting on the current threshold are
            presented. The effects of reactive and resistive feedback
            on the current threshold are discussed. Two times as large
            the bunch current than the threshold current was obtained.
             | 
              | 
        
    
        | PT19 | 
        A method for measurement of transverse impedance distribution along storage ring
         | 
        202 | 
    
    
        |   | 
        
                - V. Kiselev, V. Smaluk
 
                       BINP, Budker Institute of Nuclear Physics, Novosibirsk, Russia 
          | 
          | 
    
        
            |   | 
            
            A new method for measurement of transverse couple
            impedance distribution along storage ring is described.
            The method is based on measuring of a closed orbit
            deviation caused by local impedance. Transverse
            impedance acts on the beam as a defocusing quadrupole,
            strength of which depends on the beam current. If a local
            bump of closed orbit has been created at the impedance
            location, then the orbit deviation occurs while varying
            the beam current. The local impedance can be evaluated
            using the orbit deviation measured. Measurement
            technique is described, the method accuracy is
            evaluated. The method described was successfully used
            for measurement of the impedance distribution along the
            VEPP-4M storage ring.
             | 
              |