A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   R   S   T   U   V   W   X   Y   Z  

Liakin, D.A.

Paper Title Page
TUPB12 Beam Test of the FAIR IPM Prototype in COSY 191
 
  • V. Kamerdzhiev, J. Dietrich
    FZJ, Jülich
  • C. Böhme
    UniDo/IBS, Dortmund
  • P. Forck, T. Giacomini
    GSI, Darmstadt
  • D.A. Liakin
    ITEP, Moscow
 
 

The advanced ionization beam profile monitor is being developed at GSI for the future FAIR facility in collaboration with ITEP and FZ-Jülich. In January 2009 the IPM prototype was installed in COSY-Jülich. After successful hardware test the beam tests followed. The prototype was operated without magnetic field, thus only residual gas ions were detected. An arrangement consisting of an MCP stack, a phosphor screen, and a CCD camera was used to detect ions. We report the first profile measurements of the proton beam up to 2.8 GeV at COSY.

 
TUPD18 Longitudinal Emittance Measurement Using Particle Detectors 330
 
  • T. Milosic, P. Forck
    GSI, Darmstadt
  • D.A. Liakin
    ITEP, Moscow
 
 

A device for accessing the longitudinal phase space at low energy sections (1.4 MeV/u) of the GSI heavy ion LINAC is presented. In the course of the FAIR project optimizations of the existing facility at GSI are required. Integral information for the optimization process is extracted by the knowledge of the six dimensional phase space. Opposed to the transversal parameters it is particular difficult to access the longitudinal degree of freedom at low energies. The presented interceptive measurement is based on the coincident detection of single particles by means of two detectors: The first detector provides measurement of secondary electrons emitted from a thin Al-foil by the impinging ion beam. Secondly, after a drift of 80 cm beam particles are registered directly by a fast diamond detector. This contribution describes the measurement setup in detail including the principle of particle number attenuation by Rutherford scattering in the Ta foil. The achievements concerning the required timing resolution are presented and the investigations are accompanied by recently recorded data.