A   B   C   D   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   Y   Z    

Lallement, J.-B.

Paper Title Page
TUAY02 End-to-end beam dynamics for CERN Linac4 79
 
  • A. M. Lombardi, G. Bellodi, J.-B. Lallement, S. Lanzone, E. Zh. Sargsyan
    CERN, Geneva
  • M. A. Baylac
    LPSC, Grenoble
  • R. Duperrier, D. Uriot
    CEA, Gif-sur-Yvette
 
  LINAC 4 is a normal conducting H- linac which aims to intensify the proton flux available for the CERN accelerator complex. This injector is designed to accelerate a 65 mA beam of H- ions up to 160 MeV for injection into the CERN Proton Synchrotron Booster. The acceleration is done in three stages : up to 3 MeV with a Radio Frequency Quadrupole (the IPHI RFQ) operating at at 352 MHz, then continued to 90 MeV with drift-tube structures at 352 MHz (conventional Alvarez and Cell Coupled Drift Tube Linac) and, finally, with a Side Coupled Linac at 700MHz. The accelerator is completed by a chopper line at 3 MeV and a transport and matching line to the PS booster. After the overall layout was determined based on general consideration of beam dynamics and RF, a global optimisation based on end-to-end simulation has refined some design choices. The results and lessons learned from the end-to-end simulations are reported in this paper.  
WEBX04 Measurement strategy for the CERN Linac4 Chopper-line 262
 
  • J.-B. Lallement, K. Hanke, H. Hori, A. M. Lombardi, E. Zh. Sargsyan
    CERN, Geneva
 
  Linac4 is a new accelerator under study at CERN. It is designed to accelerate H- ions to 160 MeV of energy, for injection into the existing Proton Synchrotron Booster. The low energy section, comprising an H- ion source, a 352 MHz Radio Frequency Quadrupole and a 3 MeV chopper line will be assembled at CERN in the next years. Linac 4 is also designed as an injector for the SPL, a high power proton driver delivering 5MW at 3.5 GeV. In this case the beam losses must be limited to 1 W/m and therefore the formation of transverse and longitudinal halo at low energy becomes a critical issue which has to be measured and controlled. The chopper-line is composed of 11 quadrupoles, 3 bunchers and the chopper itself. Its beam dynamics will be characterized with specific detectors and diagnostic lines. In particular the transverse and longitudinal halo will be measured by a Beam Shape and Halo Monitor (BSHM) with a sensitivity of 10.000 particles per bunch and a time resolution of 2ns. In this paper we present the simulation work in preparation for the measurement campaign scheduled in 2008.