SRF2013 - List of Authors (Nagaitsev, S.)

Paper	Title	Page
MOP015	Status of the SRF Development for the Project X	117
	V.P. Yakovlev, T.T. Arkan, M.H. Awida, P. Berrutti, E. Borissov, A.C. Crawford, M.H. Foley, C.M. Ginsburg, I.V. Gonin, A. Grassellino, C.J. Grimm, S.D. Holmes, S. Kazakov, R.D. Kephart, T.N. Khabiboulline, V.A. Lebedev, A. Lunin, M. Merio, S. Nagaitsev, T.H. Nicol, Y.O. Orlov, D. Passarelli, T.J. Peterson, Y.M. Pischalnikov, O.V. Pronitchev, L. Ristori, A.M. Rowe, D.A. Sergatskov, N. Solyak, A.I. Sukhanov, I. Terechkine Fermilab, Batavia, USA
	Project X is a high intensity proton facility being developed to support a world-leading program of Intensity Frontier physics over the next two decades at Fermilab. The proposed facility is based on the SRF technology and consists of two linacs: CW linac to accelerate beam from 2.1 MeV to 3 GeV and pulsed linac accelerate 5% of the beam up to 8 GeV. In a CW linac five families of SC cavities are used: half-wave resonators (162.5 MHz); single-spoke cavities: SSR1 and SSR2 (325 MHz) and elliptical 5-cell β=0.6 and β=0.9 cavities (650 MHz). Pulsed 3-8 GeV linac linac are based on 9-cell 1.3 GHz cavities. In the paper the basic requirements and the status of development of SC accelerating cavities, auxiliaries (couplers, tuners, etc.) and cryomodules are presented as well as technology challenges caused by their specifics.

MOP066	Development of Compact Cryomodules Housing HWRs for High-intensity SC CW Linacs	277
	P.N. Ostroumov, Z.A. Conway, S.M. Gerbick, M. Kedzie, M.P. Kelly, S.H. Kim, S.V. Kutsaev, R.C. Murphy, B. Mustapha, T. Reid ANL, Argonne, USA D. Berkovits Soreq NRC, Yavne, Israel S. Nagaitsev Fermilab, Batavia, USA
	Funding: This work was supported by the U.S. Department of Energy, under Contracts No. DE-AC02-06CH11357, DE-AC02-76CH03000 and ANL WFO No. 85Y47. Acceleration of high-intensity light-ion beams immediately after an RFQ requires a compact accelerating and focusing lattice with a high packing factor. We have developed a cryomodule which satisfies this requirement with eight accelerating-focusing periods for Project X at FNAL. Each focusing period consist of a 162.5-MHz SC HWR, a SC solenoid and a beam position monitor. The highly optimized EM parameters of the cavity were achieved by using double conical, hour glass like, inner and outer conductors. This design is also favorable for the beam dynamics because the short focusing periods which helps to better control the beam quality. All sub-systems of the cryomodule, except the vacuum-vessel, are in advanced stages of prototyping and testing. A similar concept has been developed for the design of several cryomodules for a 20 MeV/u proton/deuteron 200 kW linac at SNRC. These cryomodules house two types of 176 MHz half-wave resonators and require only modest modifications for the application. This paper will discuss the status of the FNAL cryomodule design and sub-system fabrication and its impact on future HWR cryomodule such as the SNRC project.

Paper

Title

Page

Status of the SRF Development for the Project X

117

V.P. Yakovlev, T.T. Arkan, M.H. Awida, P. Berrutti, E. Borissov, A.C. Crawford, M.H. Foley, C.M. Ginsburg, I.V. Gonin, A. Grassellino, C.J. Grimm, S.D. Holmes, S. Kazakov, R.D. Kephart, T.N. Khabiboulline, V.A. Lebedev, A. Lunin, M. Merio, S. Nagaitsev, T.H. Nicol, Y.O. Orlov, D. Passarelli, T.J. Peterson, Y.M. Pischalnikov, O.V. Pronitchev, L. Ristori, A.M. Rowe, D.A. Sergatskov, N. Solyak, A.I. Sukhanov, I. Terechkine
Fermilab, Batavia, USA

Project X is a high intensity proton facility being developed to support a world-leading program of Intensity Frontier physics over the next two decades at Fermilab. The proposed facility is based on the SRF technology and consists of two linacs: CW linac to accelerate beam from 2.1 MeV to 3 GeV and pulsed linac accelerate 5% of the beam up to 8 GeV. In a CW linac five families of SC cavities are used: half-wave resonators (162.5 MHz); single-spoke cavities: SSR1 and SSR2 (325 MHz) and elliptical 5-cell β=0.6 and β=0.9 cavities (650 MHz). Pulsed 3-8 GeV linac linac are based on 9-cell 1.3 GHz cavities. In the paper the basic requirements and the status of development of SC accelerating cavities, auxiliaries (couplers, tuners, etc.) and cryomodules are presented as well as technology challenges caused by their specifics.

MOP066

Development of Compact Cryomodules Housing HWRs for High-intensity SC CW Linacs

277

P.N. Ostroumov, Z.A. Conway, S.M. Gerbick, M. Kedzie, M.P. Kelly, S.H. Kim, S.V. Kutsaev, R.C. Murphy, B. Mustapha, T. Reid
ANL, Argonne, USA
D. Berkovits
Soreq NRC, Yavne, Israel
S. Nagaitsev
Fermilab, Batavia, USA

Funding: This work was supported by the U.S. Department of Energy, under Contracts No. DE-AC02-06CH11357, DE-AC02-76CH03000 and ANL WFO No. 85Y47.
Acceleration of high-intensity light-ion beams immediately after an RFQ requires a compact accelerating and focusing lattice with a high packing factor. We have developed a cryomodule which satisfies this requirement with eight accelerating-focusing periods for Project X at FNAL. Each focusing period consist of a 162.5-MHz SC HWR, a SC solenoid and a beam position monitor. The highly optimized EM parameters of the cavity were achieved by using double conical, hour glass like, inner and outer conductors. This design is also favorable for the beam dynamics because the short focusing periods which helps to better control the beam quality. All sub-systems of the cryomodule, except the vacuum-vessel, are in advanced stages of prototyping and testing. A similar concept has been developed for the design of several cryomodules for a 20 MeV/u proton/deuteron 200 kW linac at SNRC. These cryomodules house two types of 176 MHz half-wave resonators and require only modest modifications for the application. This paper will discuss the status of the FNAL cryomodule design and sub-system fabrication and its impact on future HWR cryomodule such as the SNRC project.