PAC09 - List of Authors (Velev, G.)

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Velev, G.

Paper	Title	Page
MO6PFP015	Fabrication and Production Test Results of Multi-Element Corrector Magnets for the Fermilab Booster Synchrotron	163
	G. Velev, J. DiMarco, C.C. Drennan, D.J. Harding, V.S. Kashikhin, O. Kiemschies, S. Kotelnikov, J.R. Lackey, A.V. Makarov, A. Makulski, R. Nehring, D.F. Orris, W. Pellico, E. Prebys, P. Schlabach, D.G.C. Walbridge Fermilab, Batavia
	Funding: Work supported by the U.S. Department of Energy The fabrication of the multi-element corrector magnets for the Fermilab Booster synchrotron has just been completed. These water-cooled packages include six different corrector types - normal and skews oriented dipole, quadrupole and sextupole elements. They will provide full orbit control, tune and chromaticity of the beam over the whole range of Booster energies, from 0.4 GeV to 8 GeV. During production, a set of quality assurance measurements were performed, including special thermal tests. This paper summarizes the results from these measurements as well as discussing some specific steps of the magnet fabrication process.

Paper

Title

Page

MO6PFP015

Fabrication and Production Test Results of Multi-Element Corrector Magnets for the Fermilab Booster Synchrotron

163

G. Velev, J. DiMarco, C.C. Drennan, D.J. Harding, V.S. Kashikhin, O. Kiemschies, S. Kotelnikov, J.R. Lackey, A.V. Makarov, A. Makulski, R. Nehring, D.F. Orris, W. Pellico, E. Prebys, P. Schlabach, D.G.C. Walbridge
Fermilab, Batavia

Funding: Work supported by the U.S. Department of Energy

The fabrication of the multi-element corrector magnets for the Fermilab Booster synchrotron has just been completed. These water-cooled packages include six different corrector types - normal and skews oriented dipole, quadrupole and sextupole elements. They will provide full orbit control, tune and chromaticity of the beam over the whole range of Booster energies, from 0.4 GeV to 8 GeV. During production, a set of quality assurance measurements were performed, including special thermal tests. This paper summarizes the results from these measurements as well as discussing some specific steps of the magnet fabrication process.