A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Tesarek, R.

Paper Title Page
WE1GRC05 Crystal Collimation Studies at the Tevatron (T-980) 1836
 
  • N.V. Mokhov, G. Annala, A. Apyan, R.A. Carrigan, A.I. Drozhdin, T.R. Johnson, A.M. Legan, R.E. Reilly, V.D. Shiltsev, D.A. Still, R. Tesarek, J.R. Zagel
    Fermilab, Batavia
  • R.W. Assmann, V.P. Previtali, S. Redaelli, W. Scandale
    CERN, Geneva
  • Y.A. Chesnokov, I.A. Yazynin
    IHEP Protvino, Protvino, Moscow Region
  • V. Guidi
    INFN-Ferrara, Ferrara
  • Yu.M. Ivanov
    PNPI, Gatchina, Leningrad District
  • S. Peggs
    BNL, Upton, Long Island, New York
  • M. Prest
    Università dell'Insubria & INFN Milano Bicocca, Como
  • S. Shiraishi
    Enrico Fermi Institute, University of Chicago, Chicago, Illinois
 
 

Funding: Work supported by Fermi Research Alliance, LLC, under contract No. DE-AC02-07CH11359 with the U.S. Department of Energy.


Bent-crystal channeling is a technique with a potential to increase the beam-halo collimation efficiency at high-energy colliders. First measurements at the Tevatron in 2005 have shown that using a 5-mm silicon crystal to deflect the proton beam halo onto a secondary collimator improves the system performance by reducing the machine impedance, beam losses in the collider detectors and irradiation of the superconducting magnets, all in agreement with simulations. Recent results, obtained with substantially improved goniometer and enhanced beam diagnostics, are reported showing channeling collimation of the ~1-TeV circulating proton beam halo at the Tevatron collider. Comprehensive results of computer modeling are presented which allow further developments of the T-980 experiment towards a robust system compatible with requirements to high-efficient collimation at the Tevatron and LHC hadron colliders.

 

slides icon

Slides

 
TH5PFP007 Diffusion in Tevatron Using Flying Wire 3199
 
  • S. Shiraishi
    Enrico Fermi Institute, University of Chicago, Chicago, Illinois
  • R. Tesarek
    Fermilab, Batavia
 
 

Understanding beam loss in an accelerator is crucial to accelerator design and operation. Losses contribute to a shorter lifetime of a circulating beam, higher radiation doses to accelerator components, and backgrounds in experiments which use the beam. One source of beam loss is diffusion caused by effects such as beam scattering with residual gas in vacuum chamber, noise in the radio frequency acceleration system and power supplies, and beam-beam collisions. We measure the diffusion rate in the Fermilab Tevatron using the flying wire beam profile monitor. We have developed a new technique for interpreting the flying wire data. Using this technique, we measure the proton horizontal diffusion rate for ten stores in the Tevatron during colliding beam operation.