• A.B. Temnykh
  CLASSE, Ithaca, New York

Funding: Work supported by National Science Foundation under contract DMR 0225180

The paper describes the design as well as short prototype and the prototype test result of undulator magnet planned for use in Cornell Energy Recovery Linac. The prototype has pure permanent magnet (PPM) structure with 24mm period, 5mm diameter round gap and is 30cm long. In comparison with conventional undulator magnets it has: a) full X-ray polarization control; b) 40% stronger magnetic field in linear and approximately 2 times stronger in circular polarization modes; c) compactness. These advantages were achieved through a number of non-conventional approaches. Among them is control of the magnetic field strength via longitudinal motion of the magnet arrays. The moving mechanism is also used for x-ray polarization control. The compactness is achieved using a recently developed permanent magnet soldering technique for fastening PM blocks. We call this device a "Delta" undulator after the shape of it's PM blocks.

• J.A. Crittenden, I.V. Bazarov, S.A. Belomestnykh, D.H. Bilderback, M.G. Billing, J.D. Brock, E.P. Chojnacki, B.M. Dunham, M. P. Ehrlichman, M.J. Forster, S.M. Gruner, G.H. Hoffstaetter, Y. Li, M. Liepe, C.E. Mayes, A.A. Mikhailichenko, H. Padamsee, S.B. Peck, D. Sagan, V.D. Shemelin, A.B. Temnykh, M. Tigner, V. Veshcherevich
  CLASSE, Ithaca, New York
• C. Johnstone
  Fermilab, Batavia

Cornell University is planning to build an Energy-Recovery Linac (ERL) X-ray facility. In this ERL design, a 5 GeV superconducting linear accelerator extends the CESR ring which is currently used for the Cornell High Energy Synchrotron Source (CHESS). Here we describe some of the recent developments for this ERL, including linear and nonlinear optics, tracking studies, vacuum system design, gas and intra beam scattering computations, and collimator and radiation shielding calculations based on this optics, undulator developments, optimization of X-ray beams by electron beam manipulation, technical design of ERL cavities and cryomodules, and preparation of the accelerator site.

Slides

• M.A. Palmer, J.P. Alexander, M.G. Billing, J.R. Calvey, S.S. Chapman, G.W. Codner, C.J. Conolly, J.A. Crittenden, J. Dobbins, G. Dugan, E. Fontes, M.J. Forster, R.E. Gallagher, S.W. Gray, S. Greenwald, D.L. Hartill, W.H. Hopkins, J. Kandaswamy, D.L. Kreinick, Y. Li, X. Liu, J.A. Livezey, A. Lyndaker, V. Medjidzade, R.E. Meller, S.B. Peck, D.P. Peterson, M.C. Rendina, P. Revesz, D.H. Rice, N.T. Rider, D. L. Rubin, D. Sagan, J.J. Savino, R.D. Seeley, J.W. Sexton, J.P. Shanks, J.P. Sikora, K.W. Smolenski, C.R. Strohman, A.B. Temnykh, M. Tigner, S. Vishniakou, W.S. Whitney, T. Wilksen, H.A. Williams
  CLASSE, Ithaca, New York
• J.M. Byrd, C.M. Celata, J.N. Corlett, S. De Santis, M.A. Furman, A. Jackson, R. Kraft, D.V. Munson, G. Penn, D.W. Plate, A.W. Rawlins, M. Venturini, M.S. Zisman
  LBNL, Berkeley, California
• J.W. Flanagan, P. Jain, K. Kanazawa, K. Ohmi, H. Sakai, K. Shibata, Y. Suetsugu
  KEK, Ibaraki
• K.C. Harkay
  ANL, Argonne
• Y. He, M.C. Ross, C.-Y. Tan, R.M. Zwaska
  Fermilab, Batavia
• R. Holtzapple
  CalPoly, San Luis Obispo, CA
• J.K. Jones
  STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
• D. Kharakh, M.T.F. Pivi, L. Wang
  SLAC, Menlo Park, California
• E.N. Smith
  Cornell University, Ithaca, New York
• A. Wolski
  Cockcroft Institute, Warrington, Cheshire

Funding: Support provided by the US National Science Foundation, the US Department of Energy, and the Japan/US Cooperation Program.

In March of 2008, the Cornell Electron Storage Ring (CESR) concluded twenty eight years of colliding beam operations for the CLEO high energy physics experiment. We have reconfigured CESR as an ultra low emittance damping ring for use as a test accelerator (CesrTA) for International Linear Collider (ILC) damping ring R&D. The primary goals of the CesrTA program are to achieve a beam emittance approaching that of the ILC Damping Rings with a positron beam, to investigate the interaction of the electron cloud with both low emittance positron and electron beams, to explore methods to suppress the electron cloud, and to develop suitable advanced instrumentation required for these experimental studies (in particular a fast x-ray beam size monitor capable of single pass measurements of individual bunches). We report on progress with the CESR conversion activities, the status and schedule for the experimental program, and the first experimental results that have been obtained.

Slides