BNL, Upton, Long Island, New York
Omega-P, Inc., New Haven, Connecticut
Funding: Work supported by Brookhaven Science Associates, LLC under Contract No. DE-AC02-98CH10886 with the U.S. Department of Energy.
A novel tuner has been developed by the Omega-P company to achieve fast control of the accelerator RF cavity frequency. The tuner is based on the ferroelectric property which has a variable dielectric constant as function of applied voltage. Tests using a Brookhaven National Laboratory (BNL) 1.3 GHz RF cavity have been carried out for a proof-of-principle experiment of the ferroelectric tuner. Two different methods were used to determine the frequency change achieved with the ferroelectric tuner. The first method is based on a S11 measurement at the tuner port to find the reactive impedance change when the voltage is applied. The reactive impedance change then is used to estimate the cavity frequency shift. The second method is a direct S21 measurement of the frequency shift in the cavity with the tuner connected. The estimated frequency change from the reactive impedance measurement due to 5 kV is in the range between 3.2 kHz and 14 kHz, while 9 kHz is the result from the direct measurement. The two methods are in reasonable agreement. The detail description of the experiment and the analysis will be discussed in the paper.
Omega-P, Inc., New Haven, Connecticut
KEK, Ibaraki
Fermilab, Batavia
Measurements are reported for a one-third version of a L-band high-power ferroelectric phase shifter. The device is designed to allow fast adjustments of cavity coupling in an accelerator where microphonics, RF source fluctuations, or another uncontrolled fluctuations could cause undesired emittance growth. Experimental measurements of switching speed, phase shift and insertion loss vs. externally-applied voltage are presented. An average switching rate of 0.5 ns or better for each degree of RF phase has been observed.
NSC/KIPT, Kharkov
Yale University, Physics Department, New Haven, CT
Omega-P, Inc., New Haven, Connecticut
Yale University, Beam Physics Laboratory, New Haven, Connecticut
Funding: The research was supported by US Department of Energy, Office of High Energy Physics, Advanced Accelerator R & D.
A new scheme for a dielectric wakefield accelerator is proposed that em-ploys a cylindrical multi-zone dielectric structure configured as two concentric dielectric tubes with outer and inner vacuum channels for drive and accelerated bunches. Analytical and numerical studies have been carried out for such coaxial dielectric-loaded structures (CDS) for high-gradient acceleration. An analytical theory of wakefield excitation by particle bunches in a multi-zone CDS has been formulated. Numerical calculations were made for an example of a CDS using dielectric tubes of material with dielectric permittivity 5.7, having external diameters of 2.121 mm and 0.179 mm with inner diameters of 2.095 mm and 0.1 mm. An annular 5 GeV, 5 nC electron bunch with RMS length of 0.14 mm energizes a wakefield on the structure axis having an accelerating gradient of ~600 MeV/m with a transformer ratio ~8. The period of the accelerating field is ~0.38 mm. Full numerical simulation using a PIC code has confirmed results of the linear theory and furthermore has shown the important influence of the quenching wave. The simulation also has shown stable transport of drive and accelerated bunches through the CDS.
Omega-P, Inc., New Haven, Connecticut
Columbia University, New York
Yale University, Beam Physics Laboratory, New Haven, Connecticut
NSC/KIPT, Kharkov
Funding: US Department of Energy, Office of High Energy Physics, Advanced Accelerator R & D.
A rectangular two-beam dielectric wakefield accelerator (DWA) module is described which, when energized by a 14 MeV, 50 nC drive bunch moving in one channel, is shown to deflect a test bunch which originates from an independent source moving in a parallel channel. We show that such a module, 30 cm in length, can deflect transversely a 1 GeV electron by ~ 1 mrad in 1 ns, after which a following bunch can pass undeflected. Apparatus required to accomplish this task consists of a laser-cathode RF gun and an optional linac to generate the drive bunch. The associated DWA components could be used for kicker applications in a storage ring or a more energetic electron linear accelerator. An example we describe is tailored to a DWA demonstration project underway at the Argonne Wakefield Accelerator, but the design can be altered to allow for changes including a lower-energy but still relativistic drive bunch. The kicker, through appropriate design, can deflect one out of several bunches in a storage ring, leaving the remaining bunches essentially unaffected by the structure.
