A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Pellegrini, C.

Paper Title Page
WE5RFP015 Concepts for the PEP-X Light Source 2297
 
  • R.O. Hettel, K.L.F. Bane, K.J. Bertsche, Y. Cai, A. Chao, V.A. Dolgashev, J.D. Fox, X. Huang, Z. Huang, T. Mastorides, C.-K. Ng, Y. Nosochkov, A. Novokhatski, T. Rabedeau, C.H. Rivetta, J.A. Safranek, J. Seeman, J. Stohr, G.V. Stupakov, S.G. Tantawi, L. Wang, M.-H. Wang, U. Wienands, L. Xiao
    SLAC, Menlo Park, California
  • I. Lindau
    Stanford University, Stanford, California
  • C. Pellegrini
    UCLA, Los Angeles, California
 
 

Funding: This work was supported by the Director, Office of Science, Office of Basic Energy Sciences, of the U.S. Department of Energy under Contract No. DE-AC02-76SF00515.


SSRL and SLAC groups are developing a long-range plan to transfer its evolving scientific programs from the SPEAR3 light source to a much higher performing photon source that would be housed in the 2.2-km PEP-II tunnel. While various concepts for the PEP-X light source are under consideration, including ultimate storage ring and ERL configurations, the present baseline design is a very low-emittance storage ring. A hybrid lattice has DBA or QBA cells in two of the six arcs that provide a total ~30 straight sections for ID beam lines extending into two new experimental halls. The remaining arcs contain TME cells. Using ~100 m of damping wigglers the horizontal emittance at 4.5 GeV would be ~0.1 nm-rad with >1 A stored beam. PEP-X will produce photon beams having brightnesses near 1022 at 10 keV. Studies indicate that a ~100-m undulator could have FEL gain and brightness enhancement at soft x-ray wavelengths with the stored beam. Crab cavities or other beam manipulation systems could be used to reduce bunch length or otherwise enhance photon emission properties. The present status of the PEP-X lattice and beam line designs are presented and other implementation options are discussed.

 
WE5RFP040 Start-to-End Simulations of the LCLS Accelerator and FEL Performance at Very Low Charge 2355
 
  • Y.T. Ding, A. Brachmann, F.-J. Decker, D. Dowell, P. Emma, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, H. Loos, A. Miahnahri, H.-D. Nuhn, D.F. Ratner, J.L. Turner, J.J. Welch, W.E. White, J. Wu
    SLAC, Menlo Park, California
  • C. Pellegrini
    UCLA, Los Angeles, California
 
 

The Linac Coherent Light Source (LCLS) is an x-ray Free-electron Laser (FEL) being commissioned at SLAC. Recent beam measurements have shown that, using the LCLS injector-linac-compressors, the beam emittance is very small at 20 pC*. A similar low charge operation mode was also suggested and studied**. In this paper we perform start-to-end simulations of the entire accelerator including the FEL undulator and study the FEL performance versus the bunch charge. At 20 pC charge, these calculations associated with the measured beam parameters suggest the possibility of generating a longitudinally coherent single x-ray spike with 2-femtosecond duration at a wavelength of 1.5 nm. At ~100 pC charge level, our simulations show an x-ray pulse with 20 femtosecond duration and up to 1012 photons at a wavelength of 1.5 Å. These results open exciting possibilities for ultrafast science and single shot molecular imaging.


*A. Brachmann et. al., to be published.
**J. Rosenzweig et al., Nuclear Instr. and Meth. A 593, 39-44 (2008); S. Reiche et al., Nucl. Instr. And Meth. A 593, 45-48 (2008).