• B.-S. Park, Y.-S. Cho, B.H. Choi, I.-S. Hong, J.-H. Jang, H.S. Kim, K. R. Kim, H.-J. Kwon, H.R. Lee, S.P. Yun
  KAERI, Daejon

Funding: This work is supported by the Ministry of Education, Science and Technology of Korea.

PEFP (Proton Engineering Frontier Project) beamlines will be supplied either 20-MeV or 100-MeV proton beams from the 100-MeV proton linear accelerator for beam applications. Each proton beam will be transported to 2 beamlines for industrial purpose and 3 beamlines for the researches. Beam distribution to 3 research beam lines will be conducted sequentially by programmable AC magnet. To provide flexibility of the irradiation conditions, each beam line is designed to have specific beam parameters. We have designed the beamlines to the targets for wide or focused beams, external or in-vacuum beams, and horizontal or vertical beams. The detail design of each beamline will be reported.

• H.S. Kim, Y.-S. Cho, J.-H. Jang, D.I. Kim, H.-J. Kwon, B.-S. Park
  KAERI, Daejon

Funding: This work is supported by MEST of the Korean Government

A 100 MeV DTL as a main accelerating section of the PEFP proton linac is under development. The PEFP proton linac consists of a 50 keV proton injector based on a duoplasmatron ion source, 3 MeV four-vane RFQ, 20 MeV DTL and 100 MeV DTL. The 100 MeV DTL is composed of 7 tanks and each tank is an assembly of 3 sections. The tank is made of seamless carbon steel and inside surface is electroplated with copper. Each drift tube contains an electroquadrupole magnet which is made of hollow conductor and iron yoke with epoxy molding. Following the fabrication of tanks and drift tubes, a precise alignment of drift tubes and field flatness tuning procedure are performed. Currently four DTL tanks out of seven are completed and the rest are under fabrication. The status of development and test results of the fabricated parts are reported in this paper.