Rome University La Sapienza, Roma
RadiaBeam, Marina del Rey
UCLA, Los Angeles, California
INFN/LNF, Frascati (Roma)
We present here the design, including RF modelling, cooling, and thermal stress and frequency detuning, of an S-band RF gun capable of running near 500 Hz, for application to FEL and inverse Compton scattering sources. The RF design philosophy incorporates many elements in common with the LCLS gun, but the approach to managing cooling and mechanical stress diverges significantly. We examine the new proprietary approach of RadiaBeam Technologies for fabricating copper structures with intricate internal cooling geometries. We find that this approach may enable very high repetition rate, well in excess of the nominal project this design is directed for, the SPARX FEL.
*C.Limborg et al.,“RF Design of the LCLS Gun”,LCLS Technical Note LCLS-TN-05-3
**P. Frigola et al.,“A Novel Fabrication Technique for the Production of RF Photoinjectors”,published in EPAC08.
UCLA, Los Angeles, California
INFN/LNF, Frascati (Roma)
Rome University La Sapienza, Roma
A hybrid photoinjector, which we present here, consists of a 6-cell traveling wave structure with a standard 1.6-cell RF gun attached to the one end and a 3-m long linac following for further acceleration. With this structure, no reflection observed at the input port. This enables to build the accelerator without a circulator which limits the power and the frequency of RF. From the beam dynamics point of view, the beam is produced as the normal RF guns and gets short by velocity bunching in the traveling wave section right after the gun. The peak current can reach more than 1 kA, with about 2 mm.mrad of the emittance at 20 MeV. We discuss more details about the beam dynamics as well as the RF structure.
UCLA, Los Angeles, California
The velocity bunching is a hot topic in normal conducting photoinjectors to generate high-brightness beams instead of magnetic chicanes in the low energy region. We apply this technique to the superconducting photoinjectors. The linac considered here consists of several 9-cell TESLA cavities, the standard 1.6-cell normal conducting RF gun is assumed, though. In the case of 1.1 nC injection, the peak current increases to 1 kA with 2.6 mm.mrad of the emittance. The peak current can be higher but the emittance becomes worse in that case, and vice versa. We discuss more details on the spot.
UCLA, Los Angeles, California
Rome University La Sapienza, Roma
We present the status of development of a 1.5+0.5 cell photoinjector run in the blowout regime. LANL Parmela simulation results indicate a near uniform beam of slice energy spread on the order of 500 eV when neglecting thermal effects. We examine the use of an extra half cell to control longitudinal beam growth and compare the system in development with previous 1.6 cell photoinjector designs.