Paper | Title | Page |
---|---|---|
TU5PFP094 | High Power RF Testing of the EMMA RF System | 1054 |
|
||
EMMA is a prototype non-scaling FFAG that requires a demanding RF system. Production for the final RF system is due for completion in Spring 09 and testing of the combined hardware has taken place. This paper describes the high power verification tests of the IOT transmitter, waveguide distribution, RF cavity and LLRF control system. |
||
TU5PFP095 | The MICE RF System | 1057 |
|
||
The Muon Ionisation Cooling Experiment (MICE) at the Rutherford Appleton Laboratory uses normal conducting copper cavities to re-accelerate a muon beam after it has been retarded by liquid hydrogen absorbers. Each cavity operates at 200MHz and requires 1MW of RF power in a 1ms pulse at a repetition rate of 1Hz. In order to provide this power, a Thales TH116 triode, driven by a Burle 4616 tetrode is used, with each amplifier chain providing ~2.5MW. This power is then split between 2 cavities. The complete MICE RF system is described, including details of the low level RF, the power amplifiers and the coaxial power distribution system. Testing of the amplifier chain, power supplies and low level RF is described. |
||
TU5PFP096 | Operational Experience of the Superconducting RF System on ALICE at Daresbury Laboratory | 1060 |
|
||
ALICE (Accelerators and Lasers in Combined Experiments) incorporates two super-conducting radio frequency (SCRF) cryomodules each with two identical 9-cell cavities that are powered by 5 inductive output tubes (IOTs) from 3 different commercial suppliers. During the commissioning of the ALICE rf system numerous problems were encountered with the operation of the high voltage power supply and the auxiliary power supplies, which had to be resolved before the beam commissioning of the accelerator could commence. The issues encountered and measures taken to improve the operation of the rf system are described within this paper. |
||
TU5PFP097 | Design Progress of the RF System for EMMA at Daresbury Laboratory | 1063 |
|
||
EMMA (Electron Model for Many Applications) is a non-scaling Fixed Field Accelerating Gradient (NS-FFAG) accelerator presently in the process of being built at Daresbury Laboratory as a proof of principle demonstrator for proton/carbon therapy application. Its aim is to take an injected beam from ALICE (Accelerators and Lasers in Combined Experiments) at 10MeV and accelerate it to 20MeV, so that the characteristics of NS-FFAGs can be studied. The beam is to be accelerated by 19 identical 1.3GHz RF cavities, which each need to provide the same accelerating voltage to the beam. The initial design stage of the RF system design has been completed, utilising three commercial suppliers of the major RF sub-system components. |
||
TU5RFP083 | Progress on the Commissioning of ALICE, the Energy Recovery Linac-Based Light Source at Daresbury Laboratory | 1281 |
|
||
ALICE (Accelerators and Lasers in Combined Experiments) is a 35 MeV energy recovery linac based light source. ALICE is being developed as an experimental test-bed for a broad suite of science and technology activities that make use of electron acceleration and ultra-short pulse laser techniques. This paper reports the progress made in accelerator commissioning and includes the results of measurement made on the commissioning beam. The steps taken to prepare the beam for short pulse operation as a driver for a Compton Back Scattered source and in preparation for the commissioning of the free electron laser are reported. |