Fermilab, Batavia
Muons, Inc, Batavia
Funding: Supported under DOE contract DE-AC02-07CH11359.
The Mu2e experiment has been proposed at Fermilab to measure the rate for muons to convert to electrons in the field of an atomic nucleus with unprecedented precision. This experiment uses an 8 GeV primary proton beam consisting of short (~100 nsec) bunches, separated by 1.7 μs. It is vital that out-of-bunch beam be suppressed at the level of 10-9 or less. Part of the solution to this problem involves a pair of matched dipoles operating resonantly at half the bunch rate. There will be a collimation channel between them such that beam will only be transmitted when the fields are null. The magnets will be separated by 180 degrees of phase advance such that their effects cancel for all transmitted beam. Magnet optimization considerations will be discussed, as will optical design of the beam line. Simulations of the cleaning efficiency will also be presented.
Fermilab, Batavia
CERN, Geneva
IHEP Protvino, Protvino, Moscow Region
INFN-Ferrara, Ferrara
PNPI, Gatchina, Leningrad District
BNL, Upton, Long Island, New York
Università dell'Insubria & INFN Milano Bicocca, Como
Enrico Fermi Institute, University of Chicago, Chicago, Illinois
Funding: Work supported by Fermi Research Alliance, LLC, under contract No. DE-AC02-07CH11359 with the U.S. Department of Energy.
Bent-crystal channeling is a technique with a potential to increase the beam-halo collimation efficiency at high-energy colliders. First measurements at the Tevatron in 2005 have shown that using a 5-mm silicon crystal to deflect the proton beam halo onto a secondary collimator improves the system performance by reducing the machine impedance, beam losses in the collider detectors and irradiation of the superconducting magnets, all in agreement with simulations. Recent results, obtained with substantially improved goniometer and enhanced beam diagnostics, are reported showing channeling collimation of the ~1-TeV circulating proton beam halo at the Tevatron collider. Comprehensive results of computer modeling are presented which allow further developments of the T-980 experiment towards a robust system compatible with requirements to high-efficient collimation at the Tevatron and LHC hadron colliders.
Fermilab, Batavia
Funding: Work supported by Fermi Research Alliance, LLC, under contract No. DE-AC02-07CH11359 with the U.S. Department of Energy.
With a fully-operational high-efficient collimation system in the LHC, nuclear interactions of circulating protons with residual gas in the machine beam pipe can be a major sources of beam losses in the vicinity of the collider detectors, responsible for the machine-induced backgrounds. Realistic modeling of elastic and inelastic interactions of 7-TeV protons with nuclei in the vacuum chamber of the cold and warm sections of the LHC ring - with an appropriate pressure profile - is performed with the STRUCT and MARS15 codes. Multi-turn tracking of the primary beams, propagation of secondaries through the lattice, their interception by the tertiary collimators TCT as well as properties of corresponding particle distributions at the CMS and ATLAS detectors are studied in great detail and results presented in this paper.
Fermilab, Batavia
Funding: Work supported by Fermi Research Alliance, LLC under Contract No. DE-AC02-07CH11359 with the United States Department of Energy
The Fermilab Main Injector is moving toward providing 400 kW of 120 GeV proton beams using slip stacking injection of eleven Booster batches. Loss of 5% of the beam at or near injection energy results in 1.5 kW of beam loss. A collimation system has been implemented to localize this loss with the design emphasis on beam not captured in the accelerating rf buckets. More than 90% of these losses are captured in the collimation region. We will report on the construction, commissioning and operation of this collimation system. Commissioning studies and loss measurement tools will be discussed. Residual radiation monitoring of the Main Injector machine components since 2004 will be used to demonstrate the effectiveness and limitations of these efforts.
PU, Princeton, New Jersey
STFC/RAL/ASTeC, Chilton, Didcot, Oxon
STFC/RAL, Chilton, Didcot, Oxon
ORNL, Oak Ridge, Tennessee
CERN, Geneva
BNL, Upton, Long Island, New York
Fermilab, Batavia
The MERIT (MERcury Intense Target) experiment was run in the fall of 2007 using 14 and 24 GeV intense proton beams from the CERN PS. It is a proof-of-principle experiment designed to validate a target concept for producing an intense muon source for a future muon collider or neutrino factory. The experiment successfully demonstrated a target technique for multi-MW proton beams that utilizes a free-flowing liquid metal jet within the confines of a high-field solenoid. We describe the experimental strategy and parameters, as well as the results obtained and their implications for future muon-based accelerator facilities.
CERN, Geneva
STFC/RAL/ASTeC, Chilton, Didcot, Oxon
STFC/RAL, Chilton, Didcot, Oxon
ORNL, Oak Ridge, Tennessee
BNL, Upton, Long Island, New York
PU, Princeton, New Jersey
Fermilab, Batavia
The MERIT experiment is a proof-of-principle test of a target system for high power proton beam to be used as front-end for a neutrino factory complex or a muon collider. The experiment took data in autumn 2007 with the fast extracted beam from the CERN Proton Synchrotron (PS) to a maximum intensity of about 30·1012 protons per pulse. We report results from the portion of the MERIT experiment in which separated beam pulses were delivered to a free mercury jet target with time intervals between pulses varying from 2 to 700 microseconds. The analysis is based on the responses of particle detectors placed along side and downstream of the target.
BNL, Upton, Long Island, New York
STFC/RAL/ASTeC, Chilton, Didcot, Oxon
STFC/RAL, Chilton, Didcot, Oxon
ORNL, Oak Ridge, Tennessee
CERN, Geneva
PU, Princeton, New Jersey
Fermilab, Batavia
We report on the analysis of data collected from the optical diagnostics of the MERIT experiment which was run at CERN in the fall of 2007. The breakup of the free mercury jet resulting from the impact of intense proton beams from the CERN PS within a magnetic field environment is described.
BNL, Upton, Long Island, New York
Fermilab, Batavia
Funding: Work performed under the auspices of the US Department of Energy
SiO2 quartz fibers of the LHC ATLAS 0-degree calorimeter (ZDC) anticipated to experience integrated doses of a few Grad at their closest position were exposed to 200 MeV protons and neutrons at the BNL Linac. Specifically, 1mm- and 2mm- diameter quartz (GE 124) rods were exposed to direct 200 MeV protons during the first phase of exposure leading to peak integrated dose of ~28 Grad. Exposure to a primarily neutron flux of 1mm-diameter SiO2 fibers was also achieved with a special neutron source arrangement. In a post-irradiation analysis the quartz fiber transmittance was evaluated as a function of the absorbed dose. Dramatic degradation of the transmittance property was observed with increased radiation damage. In addition, detailed evaluation of the fibers under the microscope revealed interesting micro-structural damage features and irradiation-induced defects. This paper presents the results of the irradiation damage study.