A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Liu, K.-B.

Paper Title Page
TU6RFP010 TLS Corrector Magnet Power Supplies Upgrade 1553
 
  • K.-B. Liu, P.C. Chiu, K.T. Hsu, K.H. Hu, Y.-C. Lin, I. Liu, Z.-D. Tsai, C.Y. Wu
    NSRRC, Hsinchu
 
 

Corrector magnets of TLS storage ring are served with linear power supplies (corrector magnet power supplies), with some modifications the long-term output current stability and ripple of these linear power supplies were improved from 500 ppm to 50 ppm. But these linear power supplies are very low efficiency、low power factor and about 20Hz low frequency response bandwidth that waste power、noisy and unable to serve fast orbit correction. MCOR30 is a modular switching power converter with smaller volume、high efficiency and above 100Hz frequency response bandwidth, replacing these linear power supplies with MCOR30s that could save power and increasing orbit correction response.

 
TU6RFP011 Increasing Output Current Stability by Adding an External Current Control Loop 1556
 
  • K.-B. Liu, C.Y. Wu
    NSRRC, Hsinchu
 
 

The Agilient 6682A power supply is used as a dipole magnet power supply of Booster to storage ring (BTS) transport line, its output current stability is less than 100 ppm although specification is 1000 ppm. The performance of Agilient 6682A is quite good for TLS operational requirement but not suitable for less than 10 ppm output current stability general requirement of power supplies of TPS. Circuitry modification of Agilient 6682A to reach less than 10 ppm output current stability is hard to implement; but utilize analog programming function of Agilient 6682A with adding an external current control loop the output current stability of Agilient 6682A could be improved to less than 10 ppm.