BNL, Upton, Long Island, New York
Funding: US DOE Office of Basic Energy Sciences
NSLS-II is a new state-of-the-art medium energy synchrotron light source designed to deliver world leading brightness and flux with top-off operation for constant output. Design and engineering of NSLS-II began in 2005 and the beginning of construction and operations are expected to start in 2009 and 2015, respectively. The energy of the machine is 3Gev and the circumference 792 m. The chosen lattice requires tight on magnetic field tolerances for the ring magnets. These magnets have been designed with 3D Opera software. The required multipole field quality and alignment preclude the use of multifunctional sextupoles, leading to discrete corrector magnets in the storage ring. The corrector magnets are multifunctional and will provide horizontal and vertical steering as well as skew quadrupole. This paper describes the dipoles, quadrupoles, sextupoles, and corrector magnets design and prototyping status of the NSLS-II.
BNL, Upton, Long Island, New York
The NSLS II is a state of the art 3 GeV synchrotron light source being developed at BNL. The injection system will consist of a 200 MeV linac and a 3GeV booster synchrotron. The injection system must supply 7.3nC every minute to satisfy the top off requirements. A large booster acceptance is neccessary to have a high booster injection efficiency and alleviate the requirements on linac gun. We also anticipate transverse stacking of bunches in the booster to increase the amount of charge that can be delivered. We present studies of the anticipated booster stay clear including lattice errors and the ramifications for injection efficiency and transverse stacking.
BNL, Upton, Long Island, New York
Funding: NSLS-II, Brookhaven National Laboratory
NSLS-II, the third-generation light source which will be built at BNL is designed and optimized for 3 GeV energy, ultra-small emittance and high intensity of 500 mA. It will provide very bright synchrotron radiation over a large spectral range from IR to hard X-rays. Damping wigglers (DWs) are deployed to reduce the emittance of 2 nm by factors of 2-4, as well as for intense radiation sources for users. The linear and nonlinear effects induced by the DWs are integrated into the lattice design. In this paper, we discuss the linear and nonlinear optimization with DWs, and present a solution satisfying the injection and lifetime requirements. Our approach could be applied to the other light sources with strong insertion devices.
BNL, Upton, Long Island, New York
Funding: Work supported by U.S. DOE, Contract No.DE-AC02-98CH10886
Top-off injection will be adopted in NSLS-II. To ensure no injected beam can pass into experimental beamlines with open photon shutters during top-off injection, simulation studies for possible machine fault scenarios are required. We compare two available simulation methods, backward (H. Nishimura-LBL) and forward tracking (A. Terebilo-SLAC). We also discuss the tracking settings, fault scenarios, apertures and interlocks considered in our analysis.
BNL, Upton, Long Island, New York
Funding: Work supported by U.S. DOE, Contract No.DE-AC02-98CH10886
In this paper, we discuss an algorithm for constructing a numerical linear optics model for dipole magnets from a 3D field map. The difference between the numerical model and K. Brown’s analytic approach is investigated and clarified. It was found that the optics distortion due to the dipoles’ fringe focusing must be properly taken into account to accurately determine the chromaticities. In NSLS-II, there are normal dipoles with 35-mm gap and dipoles for infrared sources with 90-mm gap. This linear model of the dipole magnets is applied to the NSLS-II lattice design to match optics parameters between the DBA cells having dipoles with different gaps.
CLASSE, Ithaca, New York
Fermilab, Batavia
Cornell University is planning to build an Energy-Recovery Linac (ERL) X-ray facility. In this ERL design, a 5 GeV superconducting linear accelerator extends the CESR ring which is currently used for the Cornell High Energy Synchrotron Source (CHESS). Here we describe some of the recent developments for this ERL, including linear and nonlinear optics, tracking studies, vacuum system design, gas and intra beam scattering computations, and collimator and radiation shielding calculations based on this optics, undulator developments, optimization of X-ray beams by electron beam manipulation, technical design of ERL cavities and cryomodules, and preparation of the accelerator site.
CLASSE, Ithaca, New York
Funding: Work supported by the National Science Foundation, the US Department of Energy, and the Japan/US Cooperation Program
In concert with the ILC global design effort, the CESR is being converted into ILC Damping Ring Test Accelerator. The vacuum system is undergoing staged reconfigurations to support both the CesrTA physics goals and the CHESS X-ray sources. Six superconducting wigglers were moved to a sector with zero-dispersion. The sector is densely populated with beam instrumentation and diagnostic devices. A new photon stop chamber will be used to handle the high synchrotron radiation power generated from the SCWs at high positron beam energy. A 12-m long gate-valve isolated straight sector was created in a second location, where many electron-cloud diagnostic chambers will be installed and tested. We also configured two very short sections in the arcs, with additional gate valves, to provide flexibility of exchanging various meter-long test chambers with minimum impact to the operations. Many retarding field analyzers were integrated into the vacuum modifications in SCWs, dipoles, and drifts to study EC growth and suppression techniques. Creating environments where both local and collaborator provided equipment can be easily installed has been a major objective in the modifications.
CLASSE, Ithaca, New York
Cornell University, Ithaca, New York
JLAB, Newport News, Virginia
Cornell University has built a high average current electron injector for use with an Energy Recovery Linac. The injector is capable of up to 100 mA average current at 5 MeV (33 mA at 15 MeV) and is expected to produce the ultra low emittances needed for an ERL. This talk will give an overview of the initial performance of this injector and summarize a spectrum of beam physics experiments undertaken to demonstrate low emittance, high average current operation.
CLASSE, Ithaca, New York
LBNL, Berkeley, California
KEK, Ibaraki
SLAC, Menlo Park, California
Funding: Work supported by the National Science Foundation, the US Department of Energy, and the Japan/US Cooperation Program
Wiggler magnets are one of the key components in the ILC Damping Ring. It is critical to the ILCDR GDE to understand electron cloud (EC) growth and patterns, and to develop EC suppression techniques in the wiggler beampipes. The CESR-c superconducting wigglers, closely matching the parameters of the ILCDR wigglers, serve as unique testing vehicles. As part of the CesrTA project, we replaced the copper beampipes of two SCWs with EC diagnostic beampipes, where one of the beampipes is uncoated and the second is coated with a thin TiN film. Each of the EC diagnostic beampipes is equipped with three retarding field analyzers (RFAs) at strategic longitudinal locations in the wiggler field. Each of the RFAs has 12-fold segmentation to measure the horizontal EC density distribution. To maintain sufficient vertical beam aperture and to fit within the SCW warm bore, a thin style of RFA (with a thickness of 2.5 mm) has been developed and deployed. These SCWs with RFA-equipped beampipe have been installed and successfully operated in the re-configured CesrTA vacuum system. This paper describes the design and the construction of the RFA-equipped SCW beampipes and operational experience.
CLASSE, Ithaca, New York
Funding: Support provided by the US National Science Foundation and the US Department of Energy.
A central component of the operation of the Cornell Electron Storage Ring as a Test Accelerator (CesrTA) for ILC Damping Rings R&D is the characterization of electron cloud growth in each of the principal vacuum chamber types in use in the storage ring. In order to facilitate measurements in chambers with tightly constrained external apertures, retarding field analyzers have been developed that can be deployed in regions with as little as 3mm of available aperture. We report on the design, fabrication, characterization and operation of devices that are presently deployed in CESR drift, dipole, and wiggler chambers.
CLASSE, Ithaca, New York
LBNL, Berkeley, California
KEK, Ibaraki
ANL, Argonne
Fermilab, Batavia
CalPoly, San Luis Obispo, CA
STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
SLAC, Menlo Park, California
Cornell University, Ithaca, New York
Cockcroft Institute, Warrington, Cheshire
Funding: Support provided by the US National Science Foundation, the US Department of Energy, and the Japan/US Cooperation Program.
In March of 2008, the Cornell Electron Storage Ring (CESR) concluded twenty eight years of colliding beam operations for the CLEO high energy physics experiment. We have reconfigured CESR as an ultra low emittance damping ring for use as a test accelerator (CesrTA) for International Linear Collider (ILC) damping ring R&D. The primary goals of the CesrTA program are to achieve a beam emittance approaching that of the ILC Damping Rings with a positron beam, to investigate the interaction of the electron cloud with both low emittance positron and electron beams, to explore methods to suppress the electron cloud, and to develop suitable advanced instrumentation required for these experimental studies (in particular a fast x-ray beam size monitor capable of single pass measurements of individual bunches). We report on progress with the CESR conversion activities, the status and schedule for the experimental program, and the first experimental results that have been obtained.
NSCL, East Lansing, Michigan
BNL, Upton, Long Island, New York
Funding: this work is supported by National Science Foundation Grant PHY-0606007.
The Small Isochronous Ring (SIR) at the NSCL/MSU was built to study space charge effects in the isochronous regime. Results of experimental studies of the longitudinal beam dynamics in the ring showed a remarkable agreement with results of numerical simulations. Recently, we have designed and built an energy analyzer to accurately measure the beam energy spread. We will present results of energy spread measurements as well as simulations of the beam behavior based on the Vlasov formalism.