• C. Kim, H. J. Choi, Y.J. Han, J.Y. Huang, S.N. Kim
  PAL, Pohang, Kyungbuk

A photon-beam-position-monitor (PBPM) is installed in a diagnostic beamline of the Pohang Light Source (PLS). From experience of existing PBPMs, we enriched our understanding of the synchrotron radiation and this understanding is fully considered for physical design of the new PBPM. The newly built PBPM is tested by using a high-power ultraviolet laser and its performance is checked before installation. Measurement results of beam position shows that the current (thermal) effect is reduced significantly and they also shows good agreement with results from a beam position monitor inside the PLS storage ring.

• J.C. Yoon, C. Kim, K.R. Kim, S.J. Park
  PAL, Pohang, Kyungbuk

The prototypes of PBPM of the four blade types were installed in front-ends 1C1 diagnostic beam line. The four-blade PBPM measure both the horizontal and the vertical positions of the photon beam. KeithleyTM picoammeters are used to record the blade current. The position in both vertical and horizontal directions is calibrated by driving the stepping motors of the PBPM through an Industrial computer. PBPM Data Acquit ion Control System (DACS) is based on Window XP platform. The DACS is equipped with an Ethernet-to-GPIB controller (GPIB-ENET/00). Using the GPIB-ENET/100, networked computers can communicate with and control IEEE 488 devices from anywhere on an Ethernet-based TCP/IP network. This is GPIB interfaces four picoammeters and Ethernet-based TCP/IP communicates by Industrial Computer. Developing with LabVIEW for Windows XP, the interface to EPICS is accomplished by means of Win32 channel Access DLL's. Our LabVIEW application program incorporates EPICS-based motor control and PC-based data acquisition, using a National Instruments I/O board, and saves position data to txt files. This paper presents the PBPM DACS for PLS Control System.