JAI, Egham, Surrey
CERN, Geneva
The diagnostics of a 6D phase space distribution is a crucial and a challenging task, which is required for modern and future installations such as light sources or linear colliders, like CLIC. The longitudinal profile is one of the parameters which needs to be monitored. A setup for the investigation of coherent diffraction radiation from a conducting screen as a tool for non-invasive longitudinal electron beam profile diagnostics has been designed and installed in the CRM line of the CLIC Test Facility (CTF3) at CERN. This setup also allows the measurements of Coherent Synchrotron Radiation from the last bending magnet. In this report we present the status of the experiment and show some preliminary results on coherent synchrotron radiation and coherent diffraction radiation studies. The plans for interferometric measurements of coherent radiation are also presented.
JAI, Egham, Surrey
Diamond, Oxfordshire
Diamond is a third generation synchrotron light source built to generate infra-red, ultraviolet and X-ray synchrotron radiation (SR) of exceptional brightness. The operation of the Diamond storage ring with short electron bunches for generation of Coherent THz radiation and short X-ray pulses for time-resolved experiments is limited by the onset of microbunch instabilities. We have started a project to investigate the longitudinal electron beam dynamics and microbunch instabilities in the Diamond storage ring. In the first experiment we used an ultra-fast (time response is about 250 ps) Schottky Barrier Diode sensitive to the radiation within the 3.33-5 mm wavelength range. When the single bunch current exceeded 1.9 mA we observed a set of sub-THz bursts appearing quasi-periodically while the beam was circulating in the ring. The fast response allowed us to detect the signal turn-by-turn, which gives us an opportunity to study the bursts’ structure and evolution. It also allows us to study the effect in a multi-bunch mode when bunches are only 2 ns apart. In this report we will present our first preliminary results and also discuss future plans.
JAI, Egham, Surrey
Royal Holloway, University of London, Surrey
OXFORDphysics, Oxford, Oxon
KEK, Ibaraki
Funding: STFC LC-ABD Collaboration, Royal Society, Daiwa Foundation, Commission of European Communities under the 6th Framework Programme Structuring the European Research Area, contract number RIDS-011899
The KEK Accelerator Test Facility (ATF) extraction line laser-wire system has been upgraded, enabling the measurement of micron scale transverse size electron beams. The most recent measurements using the upgraded system are presented, including the major hardware upgrades to the laser transport, the laser beam diagnostics line, and the mechanical control systems.
SLAC, Menlo Park, California
STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
JAI, Oxford
KEK, Ibaraki
IHEP Beijing, Beijing
LAL, Orsay
Royal Holloway, University of London, Surrey
IN2P3-LAPP, Annecy-le-Vieux
OXFORDphysics, Oxford, Oxon
ATOMKI, Debrecen
CERN, Geneva
DESY, Hamburg
Fermilab, Batavia
Kyungpook National University, Daegu
PAL, Pohang, Kyungbuk
Kyoto ICR, Uji, Kyoto
ICEPP, Tokyo
University of Tokyo, Tokyo
UCL, London
BNL, Upton, Long Island, New York
Tohoku University, Graduate School of Science, Sendai
UMAN, Manchester
Hiroshima University, Graduate School of Science, Higashi-Hiroshima
Cockcroft Institute, Warrington, Cheshire
ATF2 is a final-focus test beam line that attempts to focus the low-emittance beam from the ATF damping ring to a beam size of about 37 nm, and at the same time to demonstrate nm beam stability, using numerous advanced beam diagnostics and feedback tools. The construction is well advanced and beam commissioning of ATF2 has started in the second half of 2008. ATF2 is constructed and commissioned by ATF international collaborations with strong US, Asian and European participation.
