ANL, Argonne
Funding: Work supported by U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357.
A superconducting planar undulator is under development at the Advanced Photon Source (APS). The initial R&D phase of the project includes intensive magnetic modeling performed with the Opera 2d and 3d software packages. This simulation addresses questions of magnetic design of the undulator including calculation of peak field on the undulator axis and maximum field in the conductor, superconductor load line optimization, and design of the undulator ends and correction coils. Results of the magnetic simulation are presented in the paper.
ANL, Argonne
Fermilab, Batavia
Funding: Work supported by U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357.
An extensive R&D program is underway at the Advanced Photon Source (APS) with the aim of developing a technology capable of building a 2.4-m-long superconducting planar undulator for APS users. The initial phase of the project concentrates on using a NbTi superconductor and includes magnetic modeling, development of manufacturing techniques for the undulator magnet, and design and test of short prototypes. The current status of the R&D phase of the project is described in this paper.
ANL, Argonne
HSRC, Higashi-Hiroshima
Funding: Work supported by U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357.
A request from the light source user community for insertion devices that provide only monochromatic light has led to development of quasi-periodic undulators (QPUs). These devices generate shifted harmonics in the photon energy spectrum, thus allowing suppression of higher harmonics by optical monochromator systems. Until now such undulators have been technically realized with pure permanent magnets or with hybrid structures. A concept for a superconducting quasi-periodic undulator (SCQPU) is suggested and described in this paper.
ANL, Argonne
Funding: Work supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences, under Contract No. DE-AC02-06CH11357.
The baseline configuration of the proposed International Linear Collider includes superconducting helical undulators as a scheme to produce positrons. This paper presents a conceptual design of the magnetic field measurement system for helical undulators with the undulator axis in a horizontal direction at liquid helium temperature. The system consists of a cryomodule and a linear stage unit with a travel length of approximately 3.5 m. The linear stage unit provides the motion control for the Hall probe housing, which is connected to a small-diameter carbon fiber rod inside bellows-flange connections. Stainless steel bellows are at the same vacuum pressure as the cold mass in the cryomodule. A linear encoder is used for motion control of the stage, but precise position measurement of the Hall probe relies on the laser interferometer system.
STFC/RAL/ASTeC, Chilton, Didcot, Oxon
Lancaster University, Lancaster
STFC/RAL, Chilton, Didcot, Oxon
STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
ANL, Argonne
Durham University, Durham
University of Bristol, Bristol
The ILC positron source relies upon a ~200 m long superconducting helical undulator in order to generate the huge flux of gamma photons required. The period is only 11.5 mm but the field strength is ~1 T. The UK is building and testing a full scale 4 m long ILC cryomodule at the moment. It will be completed in 2008 and the results used to demonstrate the feasibility of the full (200 m long) system.
