• R.O. Hettel, K.L.F. Bane, K.J. Bertsche, Y. Cai, A. Chao, V.A. Dolgashev, J.D. Fox, X. Huang, Z. Huang, T. Mastorides, C.-K. Ng, Y. Nosochkov, A. Novokhatski, T. Rabedeau, C.H. Rivetta, J.A. Safranek, J. Seeman, J. Stohr, G.V. Stupakov, S.G. Tantawi, L. Wang, M.-H. Wang, U. Wienands, L. Xiao
  SLAC, Menlo Park, California
• I. Lindau
  Stanford University, Stanford, California
• C. Pellegrini
  UCLA, Los Angeles, California

Funding: This work was supported by the Director, Office of Science, Office of Basic Energy Sciences, of the U.S. Department of Energy under Contract No. DE-AC02-76SF00515.

SSRL and SLAC groups are developing a long-range plan to transfer its evolving scientific programs from the SPEAR3 light source to a much higher performing photon source that would be housed in the 2.2-km PEP-II tunnel. While various concepts for the PEP-X light source are under consideration, including ultimate storage ring and ERL configurations, the present baseline design is a very low-emittance storage ring. A hybrid lattice has DBA or QBA cells in two of the six arcs that provide a total ~30 straight sections for ID beam lines extending into two new experimental halls. The remaining arcs contain TME cells. Using ~100 m of damping wigglers the horizontal emittance at 4.5 GeV would be ~0.1 nm-rad with >1 A stored beam. PEP-X will produce photon beams having brightnesses near 1022 at 10 keV. Studies indicate that a ~100-m undulator could have FEL gain and brightness enhancement at soft x-ray wavelengths with the stored beam. Crab cavities or other beam manipulation systems could be used to reduce bunch length or otherwise enhance photon emission properties. The present status of the PEP-X lattice and beam line designs are presented and other implementation options are discussed.

• Y.T. Ding, A. Brachmann, F.-J. Decker, D. Dowell, P. Emma, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, H. Loos, A. Miahnahri, H.-D. Nuhn, D.F. Ratner, J.L. Turner, J.J. Welch, W.E. White, J. Wu
  SLAC, Menlo Park, California
• C. Pellegrini
  UCLA, Los Angeles, California

The Linac Coherent Light Source (LCLS) is an x-ray Free-electron Laser (FEL) being commissioned at SLAC. Recent beam measurements have shown that, using the LCLS injector-linac-compressors, the beam emittance is very small at 20 pC*. A similar low charge operation mode was also suggested and studied**. In this paper we perform start-to-end simulations of the entire accelerator including the FEL undulator and study the FEL performance versus the bunch charge. At 20 pC charge, these calculations associated with the measured beam parameters suggest the possibility of generating a longitudinally coherent single x-ray spike with 2-femtosecond duration at a wavelength of 1.5 nm. At ~100 pC charge level, our simulations show an x-ray pulse with 20 femtosecond duration and up to 1012 photons at a wavelength of 1.5 Å. These results open exciting possibilities for ultrafast science and single shot molecular imaging.

*A. Brachmann et. al., to be published.
**J. Rosenzweig et al., Nuclear Instr. and Meth. A 593, 39-44 (2008); S. Reiche et al., Nucl. Instr. And Meth. A 593, 45-48 (2008).

• H. Geng, Y.T. Ding, Z. Huang
  SLAC, Menlo Park, California
• H. Geng
  USTC/NSRL, Hefei, Anhui

There is a growing interest in producing intense, coherent x-ray radiation with an adjustable and arbitrary polarization state. The crossed-planar undulator* was first proposed by Kim for rapid polarization control in synchrotron radiation and free electron laser (FEL). Recently, a statistical analysis shows a degree of polarization over 80% is obtainable for a SASE FEL near saturation**. In such a scheme, nonlinear harmonic radiation is generated in each undulator and its polarization is controllable in the same manner. In this paper, we study the degree of polarization for the nonlinear harmonic radiation. We also discuss methods to reduce the FEL power fluctuations by operating the crossed undulator in the saturation regime.

*K.-J. Kim, Nucl. Instrum. Methods A 445, 329 (2000)
**Y. Ding and Z. Huang, Phys. Rev. ST Accel. Beams 11, 030702 (2008)

• H. Geng, Y.T. Ding, P. Emma, Z. Huang, Y. Nosochkov, M. Woodley
  SLAC, Menlo Park, California

Funding: This work is supported by the Department of Energy contract DE-AC02-76SF00515.

LCLS capabilities can be significantly extended with a second undulator aiming at the soft x-ray spectrum (1- 5 nm). To allow for simultaneous hard and soft x-ray operations, 14 GeV beams at the end of the LCLS accelerator can be intermittently switched into the SLAC A-line (the beam transport line to End Station A) where the second undulator may be located. In this paper, we discuss the A-line optics design for transporting the high-brightness LCLS beams using the existing tunnel. To preserve the high brightness of the LCLS beams, special attentions are paid to effects of incoherent and coherent synchrotron radiation. Start-to-end simulations using realistic LCLS beam distributions are carried out.

• F.-J. Decker, R. Akre, A. Brachmann, W.S. Colocho, Y.T. Ding, D. Dowell, P. Emma, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, K.D. Kotturi, A. Krasnykh, H. Loos, A. Miahnahri, H.-D. Nuhn, D.F. Ratner, J.L. Turner, J.J. Welch, W.E. White, J. Wu
  SLAC, Menlo Park, California

Funding: Work supported by Department of Energy contract DE-AC03-76SF00515.

The beam stability for the Linac Coherent Light Source (LCLS) at SLAC is important for good X-Ray operation. Although most of the jitter tolerances are met, there is always room for improvement. Besides the short term pulse-to-pulse jitter, we will also discuss oscillation sources of longer time cycles from seconds (feedbacks), to minutes (cooling systems), and up to the 24 hours caused by the day-night temperature variations.

• F.-J. Decker, R. Akre, K.J. Bertsche, A. Brachmann, W.S. Colocho, Y.T. Ding, D. Dowell, P. Emma, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, A. Krasnykh, H. Loos, H.-D. Nuhn, D.F. Ratner, H. Smith, J.L. Turner, J.J. Welch, W.E. White, J. Wu
  SLAC, Menlo Park, California

Funding: Work supported by Department of Energy contract DE-AC03-76SF00515.

The electron beam for the Linac Coherent Light Source (LCLS) at SLAC is accelerated by disk-loaded RF structures over a length of 1 km. The mainly longitudinal field can sometimes exhibit transverse components, which kick the beam in x and/or y. This is normally a stable situation, but when a klystron, which powers some of these structures, has to be switched off and another one switched on, different kicks can lead to quite a different orbit. Some klystrons, configured in an energy and bunch length feedback, caused orbit changes of up to 1 mm, which is about 20 times the σ beam size. The origins and measurements of these kicks and some efforts (orbit bumps) to reduce them will be discussed.

• P. Emma, R.F. Boyce, A. Brachmann, R. Carr, F.-J. Decker, Y.T. Ding, D. Dowell, S.A. Edstrom, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, Yu.I. Levashov, H. Loos, A. Miahnahri, H.-D. Nuhn, B.D. Poling, D.F. Ratner, J.L. Turner, J.J. Welch, W.E. White, Z.R. Wolf, J. Wu
  SLAC, Menlo Park, California
• S. Spampinati
  ELETTRA, Basovizza

Funding: Work supported by the U.S. Dept. of Energy contract #DE-AC02-76SF00515.

The Linac Coherent Light Source (LCLS) is an x-ray Free-Electron Laser (FEL) project presently in a commissioning phase at SLAC. The very bright electron beam required for the FEL is also susceptible to a micro-bunching instability* in the magnetic bunch compressors, prior to the FEL undulator. The uncorrelated electron energy spread can be increased by an order of magnitude to provide strong Landau damping against the instability without degrading the free-electron laser performance. To this end, a ‘laser-heater’ system has been installed in the LCLS injector, which modulates the energy of a 135-MeV electron bunch with an IR laser beam in a short undulator, enclosed within a four-dipole chicane. The last half of the chicane time-smears the energy modulation leaving an effective thermal energy spread increase. We present the first commissioning results of this system, its operational issues, and its impact on the micro-bunching instability.

*Z. Huang et. al., Phys. Rev. ST Accel. Beams 7, 074401 (2004).

• J. Wu, R. Akre, A. Brachmann, P. Chu, F.-J. Decker, Y.T. Ding, D. Dowell, S.A. Edstrom, P. Emma, D. Fairley, J.C. Frisch, A. Gilevich, G.R. Hays, P. Hering, Z. Huang, R.H. Iverson, H. Loos, A. Miahnahri, H.-D. Nuhn, D.F. Ratner, J.L. Turner, J.J. Welch, W.E. White, D. Xiang
  SLAC, Menlo Park, California
• E. Meier
  ASCo, Clayton, Victoria

Funding: Work supported by Department of Energy contract DE-AC02-76SF00515. This work was performed in support of the LCLS project at SLAC

The Linac Coherent Light Source is an x-ray Free-Electron Laser (FEL) project being commissioned at SLAC. The very bright electron beam required for the FEL is subjected to various sources of jitter along the accelerator. The peak current, centroid energy, and trajectory of the electron bunch are controlled precisely at the highest repetition rate possible with feedback systems. We report commissioning experience for these systems. In particular, there is high frequency content in the electron bunch current spectrum, and we report its impact on the systems. Due to the coupling of the betatron motion and the dispersion component of the electron trajectory, a fast in-line model* is incorporated. For the longitudinal feedback, we report the performance of two different configurations: one with RF system as direct actuators, which are nonlinear, and the other with artificially formed linear energy and energy-chirp actuators. Since the electron bunch is compressed to a final peak current of 2 to 3 kA, coherent synchrotron radiation and other wakefields are included for precise control of the electron bunch parameters. Machine performance is compared to start-to-end simulations.

*P. Chu et al., these PAC09 proceedings