RadiaBeam, Marina del Rey
UCLA, Los Angeles, California
NCSU, Raleigh, North Carolina
INFN/LNF, Frascati (Roma)
Electron beam based additive fabrication techniques have been successfully applied to produce a variety of complex, fully dense, metal structures. These methods, collectively known as Solid Freeform Fabrication (SFF) are now being explored for use in radio frequency (RF) structures. SFF technology may make it possible to design and produce near-netshape copper structures for the next generation of very high duty factor, high gradient RF photoinjectors. The SFF process discussed here, Arcam Electron Beam Melting (EBM), utilizes an electron beam to melt metal powder in a layer-by-layer fashion. The additive nature of the SFF process and its ability to produce fully dense parts are explored for the fabrication of internal cooling passages in RF photoinjectors. Following an initial feasibility study of the SFF process, we have fabricated a copper photocathode, suitable as a drop-in replacement for the UCLA 1.6 cell photoinjector, with internal cooling channels using SFF. Material analysis of the prototype cathode and new designs for a high duty factor photoinjector utilizing SFF technology will be presented.
Rome University La Sapienza, Roma
RadiaBeam, Marina del Rey
UCLA, Los Angeles, California
INFN/LNF, Frascati (Roma)
We present here the design, including RF modelling, cooling, and thermal stress and frequency detuning, of an S-band RF gun capable of running near 500 Hz, for application to FEL and inverse Compton scattering sources. The RF design philosophy incorporates many elements in common with the LCLS gun, but the approach to managing cooling and mechanical stress diverges significantly. We examine the new proprietary approach of RadiaBeam Technologies for fabricating copper structures with intricate internal cooling geometries. We find that this approach may enable very high repetition rate, well in excess of the nominal project this design is directed for, the SPARX FEL.
*C.Limborg et al.,“RF Design of the LCLS Gun”,LCLS Technical Note LCLS-TN-05-3
**P. Frigola et al.,“A Novel Fabrication Technique for the Production of RF Photoinjectors”,published in EPAC08.
UCLA, Los Angeles, California
Rome University La Sapienza, Roma
We present the status of development of a 1.5+0.5 cell photoinjector run in the blowout regime. LANL Parmela simulation results indicate a near uniform beam of slice energy spread on the order of 500 eV when neglecting thermal effects. We examine the use of an extra half cell to control longitudinal beam growth and compare the system in development with previous 1.6 cell photoinjector designs.