• I.V. Bazarov, S.A. Belomestnykh, E.P. Chojnacki, J. Dobbins, B.M. Dunham, R.D. Ehrlich, M.J. Forster, C.M. Gulliford, G.H. Hoffstaetter, Y. Li, M. Liepe, X. Liu, F. Löhl, D.G. Ouzounov, H. Padamsee, D.H. Rice, V.D. Shemelin, E.N. Smith, K.W. Smolenski, M. Tigner, V. Veshcherevich
  CLASSE, Ithaca, New York
• H. Li
  Cornell University, Ithaca, New York
• H. K. Sayed
  JLAB, Newport News, Virginia

Cornell University has built a high average current electron injector for use with an Energy Recovery Linac. The injector is capable of up to 100 mA average current at 5 MeV (33 mA at 15 MeV) and is expected to produce the ultra low emittances needed for an ERL. This talk will give an overview of the initial performance of this injector and summarize a spectrum of beam physics experiments undertaken to demonstrate low emittance, high average current operation.

Slides

• E.P. Chojnacki, S.A. Belomestnykh, S.S. Chapman, R.D. Ehrlich, G.H. Hoffstaetter, M. Liepe, H. Padamsee, J. Sears, E.N. Smith, V. Veshcherevich
  CLASSE, Ithaca, New York

Funding: Work supported by NSF, New York State, and Cornell University

A cryomodule design for the Cornell Energy Recovery Linac (ERL) will be based on TTF technology, but must have several unique features dictated by the ERL beam parameters. The main deviations from TTF are that the HOM loads must be on the beamline for sufficient damping, that the average power through the RF couplers is low, and that cw beam operation introduces higher heat loads. Several of these challenges were addressed for the Cornell ERL Injector, from which fabrication and operational insight was gained. A baseline design for the Cornell ERL Linac cryomodule will be presented that includes fabrication and operational considerations along with thermal and mechanical analyses.