A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Christian, G.B.

Paper Title Page
WE6PFP077 Beam Test Results with the FONT4 ILC Prototype Intra-Train Beam Feedback System 2676
 
  • P. Burrows, R. Apsimon, C.I. Clarke, B. Constance, H. Dabiri Khah, A.F. Hartin, C. Perry, J. Resta-López, C. Swinson
    JAI, Oxford
  • G.B. Christian
    ATOMKI, Debrecen
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
 
 

We present the results of beam tests of the FONT4 ILC prototype intra-train beam feedback system. The system comprises a stripline BPM, a fast analogue BPM signal processor, a custom FPGA-based digital feedback board, a high-power fast-response drive amplifier, and a stripline kicker. The hardware was deployed at the Accelerator Test Facility at KEK. Trains comprising three electron bunches were extracted from the ATF damping ring, with bunch spacing c. 150ns. The feedback loop was closed by measuring the position of bunch 1 and correcting bunches 2 and 3. We report the performance of the feedback, including gain studies, the correction dynamic range, latency measurement, and quality of the beam position correction. The system achieved micron-level bunch stabilisation with a latency of c. 140ns.

 
TH6REP074 Development of a Fast Micron-Resolution Beam Position Monitor Signal Processor for Linear Collider Beam-Based Feedback Systems 4126
 
  • P. Burrows, R. Apsimon, C.I. Clarke, B. Constance, H. Dabiri Khah, A.F. Hartin, C. Perry, J. Resta-López, C. Swinson
    JAI, Oxford
  • G.B. Christian
    ATOMKI, Debrecen
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
 
 

We present the design of prototype fast beam position monitor (BPM) signal processors for use in inter-bunch beam-based feedbacks for linear colliders and electron linacs. We describe the FONT4 intra-train beam-based digital position feedback system prototype deployed at the Accelerator test facility (ATF) extraction line at KEK, Japan. The system incorporates a fast analogue beam position monitor front-end signal processor, a digital feedback board, and a fast kicker-driver amplifier. The total feedback system latency is less than 150ns, of which less than 10ns is used for the BPM processor. We report preliminary results of beam tests using electron bunches separated by c. 150ns. Position resolution of order 1 micron is obtained.

 
FR1RAI03 ATF2 Commissioning 4205
 
  • A. Seryi, J.W. Amann, P. Bellomo, B. Lam, D.J. McCormick, J. Nelson, J.M. Paterson, M.T.F. Pivi, T.O. Raubenheimer, C.M. Spencer, M.-H. Wang, G.R. White, W. Wittmer, M. Woodley, Y.T. Yan, F. Zhou
    SLAC, Menlo Park, California
  • D. Angal-Kalinin, J.K. Jones
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • R. Apsimon, B. Constance, C. Perry, J. Resta-López, C. Swinson
    JAI, Oxford
  • S. Araki, A.S. Aryshev, H. Hayano, Y. Honda, K. Kubo, T. Kume, S. Kuroda, M. Masuzawa, T. Naito, T. Okugi, R. Sugahara, T. Tauchi, N. Terunuma, J. Urakawa, K. Yokoya
    KEK, Ibaraki
  • S. Bai, J. Gao
    IHEP Beijing, Beijing
  • P. Bambade, Y. Renier, C. Rimbault
    LAL, Orsay
  • G.A. Blair, S.T. Boogert, V. Karataev, S. Molloy
    Royal Holloway, University of London, Surrey
  • B. Bolzon, N. Geffroy, A. Jeremie
    IN2P3-LAPP, Annecy-le-Vieux
  • P. Burrows
    OXFORDphysics, Oxford, Oxon
  • G.B. Christian
    ATOMKI, Debrecen
  • J.-P. Delahaye, D. Schulte, R. Tomás, F. Zimmermann
    CERN, Geneva
  • E. Elsen
    DESY, Hamburg
  • E. Gianfelice-Wendt, M.C. Ross, M. Wendt
    Fermilab, Batavia
  • A. Heo, E.-S. Kim, H.-S. Kim
    Kyungpook National University, Daegu
  • J.Y. Huang, W.H. Hwang, S.H. Kim, Y.J. Park
    PAL, Pohang, Kyungbuk
  • Y. Iwashita, T. Sugimoto
    Kyoto ICR, Uji, Kyoto
  • Y. Kamiya
    ICEPP, Tokyo
  • S. Komamiya, M. Oroku, T.S. Suehara, T. Yamanaka
    University of Tokyo, Tokyo
  • A. Lyapin
    UCL, London
  • B. Parker
    BNL, Upton, Long Island, New York
  • T. Sanuki
    Tohoku University, Graduate School of Science, Sendai
  • A. Scarfe
    UMAN, Manchester
  • T. Takahashi
    Hiroshima University, Graduate School of Science, Higashi-Hiroshima
  • A. Wolski
    Cockcroft Institute, Warrington, Cheshire
 
 

ATF2 is a final-focus test beam line that attempts to focus the low-emittance beam from the ATF damping ring to a beam size of about 37 nm, and at the same time to demonstrate nm beam stability, using numerous advanced beam diagnostics and feedback tools. The construction is well advanced and beam commissioning of ATF2 has started in the second half of 2008. ATF2 is constructed and commissioned by ATF international collaborations with strong US, Asian and European participation.

 

slides icon

Slides