• R. Visintini, M. Cautero, D.M. Molaro
  ELETTRA, Basovizza

Funding: The work was supported in part by the Italian Ministry of University and Research under grant FIRB-RBAP045JF2

FERMI@Elettra is the new 4th-generation light source, based on a single-pass FEL, under construction at the Elettra Laboratory in Trieste, Italy. Some hundreds of magnets and coils need to be supplied along the accelerator sections and the undulators chains - mostly individually - with currents as low as 1.5 A up to 750 A. Starting from a successful design developed at Elettra* for the full-energy injector**, a new version of the existing 4-quadrant, 5 A PS has been studied. This new bipolar low-current PS, with full digital control, will be adopted for all 1.5 A and 5 A loads. The design of a bipolar PS for supplying the 20 A loads is in progress. This paper will describe the proposed PS system for the magnets and coils of FERMI@Elettra. The focus will be on the solutions adopted to minimize the number of different PS types. Particular stress will be laid upon the in-house design.

*D, Molaro et al. - A new bipolar power supply for Elettra booster pre-injector correctors - PCIM08
**R. Visintini et al. - Magnet power converters for the new Elettra full energy injector - EPAC08