Paper |
Title |
Page |
TUPME008 |
Status of the CLIC-UK R&D Programme on Design of Key Systems for the Compact Linear Collider |
1354 |
|
- P. Burrows, R. Ainsworth, T. Aumeyr, D.R. Bett, N. Blaskovic Kraljevic, L.M. Bobb, S.T. Boogert, A. Bosco, G.B. Christian, L. Corner, F.J. Cullinan, M.R. Davis, D. Gamba, P. Karataev, K.O. Kruchinin, A. Lyapin, L.J. Nevay, C. Perry, J. Roberts, J. Snuverink, J.R. Towler
JAI, Egham, Surrey, United Kingdom
- R. Ainsworth, T. Aumeyr, S.T. Boogert, A. Bosco, P. Karataev, K.O. Kruchinin, L.J. Nevay, J.R. Towler
Royal Holloway, University of London, Surrey, United Kingdom
- P.K. Ambattu, G. Burt, A.C. Dexter, M. Jenkins, S. Karimian, C. Lingwood, B.J. Woolley
Cockcroft Institute, Lancaster University, Lancaster, United Kingdom
- L.M. Bobb, R. Corsini, D. Gamba, A. Grudiev, A. Latina, T. Lefèvre, C. Marrelli, M. Modena, J. Roberts, H. Schmickler, D. Schulte, P.K. Skowroński, J. Snuverink, S. Stapnes, F. Tecker, R. Tomás, R. Wegner, M. Wendt, W. Wuensch
CERN, Geneva, Switzerland
- J.A. Clarke, S.P. Jamison, P.A. McIntosh, B.J.A. Shepherd
STFC/DL/ASTeC, Daresbury, Warrington, Cheshire, United Kingdom
- N.A. Collomb, D.G. Stokes
STFC/DL, Daresbury, Warrington, Cheshire, United Kingdom
- L. Corner
Oxford University, Physics Department, Oxford, Oxon, United Kingdom
- W.A. Gillespie, R. Pan, M.A. Tyrk, D.A. Walsh
University of Dundee, Nethergate, Dundee, Scotland, United Kingdom
- R.M. Jones
UMAN, Manchester, United Kingdom
|
|
|
Six UK institutes are engaged in a collaborative R&D programme with CERN aimed at demonstrating key aspects of technology feasibility for the Compact Linear Collider (CLIC). We give an overview and status of the R&D being done on: 1) Drive-beam components: quadrupole magnets and the beam phase feed-forward prototype. 2) Beam instrumentation: stripline and cavity beam position monitors, an electro-optical longitudinal bunch profile monitor, and laserwire and diffraction and transition radiation monitors for transverse beam-size determination. 3) Beam delivery system and machine-detector interface design, including beam feedback/control systems and crab cavity design and control. 4) RF structure design. In each case, where applicable, we report on the status of prototype systems and performance tests with beam at the CTF3, ATF2 and CesrTA test facilities, including plans for future experiments.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IPAC2014-TUPME008
|
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|
TUPME009 |
A Sub-micron Resolution, Wide-band, Stripline BPM System for Driving Bunch-by-bunch Feed-back and Feed-forward Systems at ATF |
1358 |
|
- G.B. Christian, D.R. Bett, N. Blaskovic Kraljevic, P. Burrows, M.R. Davis, Y.I. Kim, C. Perry
JAI, Oxford, United Kingdom
|
|
|
A low-latency, sub-micron resolution stripline beam position monitoring (BPM) system has been developed and tested with beam at the KEK Accelerator Test Facility (ATF2), where it has been used as part of a beam stabilisation system. The fast analogue front-end signal processor is based on a single-stage RF down-mixer and a position resolution below 400 nm has been demonstrated for beam intensities of ~1 nC, with single-pass beam. The BPM position data are digitised by fast ADCs on an FPGA-based digital feedback controller, which is used to drive either a pair of kickers local to the BPMs and nominally orthogonal in phase, in closed-loop feedback mode, or a downstream kicker in the ATF2 final focus region, in feedforward mode. The beam jitter is measured downstream of the final focus system with high resolution, low-Q, cavity BPMs, and the relative performance of both systems in stabilising the beam is compared.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IPAC2014-TUPME009
|
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|
THOAA02 |
Development of a Low-latency, High-precision, Intra-train Beam Feedback System Based on Cavity Beam Position Monitors |
2783 |
SUSPSNE084 |
|
|
- N. Blaskovic Kraljevic, D.R. Bett, P. Burrows, G.B. Christian, M.R. Davis, Y.I. Kim, C. Perry
JAI, Oxford, United Kingdom
|
|
|
A low-latency, intra-train, beam feedback system utilising a cavity beam position monitor (BPM) has been developed and tested at the final focus of the Accelerator Test Facility (ATF2) at KEK. A low-Q cavity BPM was utilised with custom signal processing electronics, designed for low latency and optimal position resolution, to provide an input beam position signal to the feedback system. A custom stripline kicker and power amplifier, and an FPGA-based digital feedback board, were used to provide beam correction and feedback control, respectively. The system was deployed in single-pass, multi-bunch mode with the aim of demonstrating intra-train beam stabilisation on electron bunches of charge ~ 1nC separated in time by c. 280ns. The system has been used to demonstrate beam stabilisation to below the 100nm level. Results of the latest beam tests, aimed at even higher performance, will be presented.
|
|
|
Slides THOAA02 [2.050 MB]
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IPAC2014-THOAA02
|
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|