Paper |
Title |
Page |
MOPRO069 |
Progress Status of the Iranian Light Source Facility Laboratory |
240 |
|
- J. Rahighi, E. Ahmadi, H. Ajam, M. Akbari, S. Amiri, J. Dehghani, R. Eghbali, S. Fatehi, M. Fereidani, A. Gholampour, A. Iraji, M. Jafarzadeh, B. Kamkari, S. Kashani, P. Khodadoost, H. Khosroabadi, M. Lamehi, M. Moradi, H. Oveisi, S. Pirani, M. Rahimi, N. Ranjbar, R. Rasoli, M. Razazian, A. Sadeghipanah, F. Saeidi, R. Safian, E. Salimi, Kh.S. Sarhadi, O. Seify, M.Sh. Shafiee, A. Shahveh, Z. Shahveh, A. Shahverdi, D. Shirangi, E.H. Yousefi
ILSF, Tehran, Iran
- D. Einfeld
CELLS-ALBA Synchrotron, Cerdanyola del Vallès, Spain
- H. Ghasem
IPM, Tehran, Iran
|
|
|
The Iranian Light Source Facility Project (ILSF) is a 3 GeV third generation light source with a current of 400 mA which will be built on a land of 50 hectares area in the city of Qazvin, located 150 km West of Tehran. ILSF conceptual design report, CDR, was published in October 2012. To have a competitive leading position in the future, 489.6 m storage ring of ILSF is designed to emphasize on small emittance electron beam( 0.93 nm-rad), high photon flux density, brightness, stability and reliability. Moreover, 40% of 489.6 m ring circumference is straight sections (14×8 m+ 14×6 m) which are long enough for the commonly used insertion devices. Some prototype accelerator components such as high power solid state radio frequency amplifiers, LLRF system, thermionic RF gun, Storage ring H-type dipole and quadruple magnets, Hall probe system for magnetic measurement and highly stable magnet power supplies have been constructed in ILSF R&D laboratory.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IPAC2014-MOPRO069
|
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|
WEPME006 |
DESIGN AND CONSTRUCTION OF A 4 KW, 500 MHZ SOLID STATE RF AMPLIFIER AT IRANIAN LIGHT SOURCE FACILITY (ILSF) |
2264 |
|
- A. Shahverdi, H. Ajam, H. Ghasem, Kh.S. Sarhadi
ILSF, Tehran, Iran
|
|
|
Solid state RF power amplifiers have been considered as an attractive candidate for providing the high power RF power required in increasing number of accelerator applications in recent years. Due to the advantages of these amplifiers and based on the successful experience done in other light sources; ILSF RF group has started R&D in design and fabrication of solid state amplifiers. Two modules based on two different LDMOS transistors have been developed successfully at 500MHz. The measured characteristics are presented and compared in this paper. Combining of 8 such modules is under test to achieve 4kW output power as the first stage of the conceptually designed combining network. This paper outlines the design concept of the different parts of the amplifiers and presents the experimental results obtained so far.
|
|
DOI • |
reference for this paper
※ https://doi.org/10.18429/JACoW-IPAC2014-WEPME006
|
|
Export • |
reference for this paper using
※ BibTeX,
※ LaTeX,
※ Text/Word,
※ RIS,
※ EndNote (xml)
|
|
|