| Paper | Title | Page |
|---|---|---|
| MOPEB004 | Magnetic Modeling, Measurements and Sorting of the CNAO Synchrotron Dipoles and Quadrupoles | 280 |
|
||
|
CNAO is a synchrotron accelerator presently under commissioning in Pavia. The aim of this accelerator is to treat tumors with hadrons and to perform advanced clinical and radiobiological research. The CNAO will start treating patients with protons (60-250 MeV range) and carbon ions (120-400 MeV/u range) in three treatment rooms with four beam lines. Future upgrade with gantries is foreseen. This paper describes the design, magnetic measurements and sorting criterion used for the sixteen synchrotron main dipoles and twenty-four quadrupoles. The magnetic measurements results are compared with magnetic simulation. |
||
| TUPEB003 | The SuperB Project Accelerator Status | 1518 |
|
||
|
The SuperB project is an international effort aiming at building in Italy a very high luminosity e+e- (1036 cm-2 sec-1) asymmetric collider at the B mesons cm energy. The accelerator design has been extensively studied and changed during the past year. The present design, - based on the new collision scheme, with large Piwinski angle and the use of 'crab' sextupoles, which has been successfully tested at the DAPHNE Phi-Factory at LNF Frascati, - provides larger flexibility, better dynamic aperture and in the Low Energy Ring spin manipulation sections, needed for having longitudinal polarization of the electron beam at the Interaction Point. The Interaction Region has been further optimized in terms of apertures and reduced backgrounds in the detector. The injector complex design has been also updated. A summary of the design status, including details on lattice and spin manipulation will be presented in this paper. |
||
| TUPEB006 | DAΦNE Developments for the KLOE-2 Experimental Run | 1527 |
|
||
|
Recently the peak luminosity achieved on the DAΦNE collider has been improved by almost a factor 3 by implementing a novel collision scheme based on large Piwinski angle and Crab-Waist. This encouraging result opened new perspectives for physics research and a new run with the KLOE-2 detector has been scheduled to start by spring 2010. The KLOE-2 installation is a complex operation requiring a careful design effort and a several months long shutdown. The high luminosity interaction region has been deeply revised in order to take into account the effect on the beam caused by the solenoidal field of the experimental detector and to ensure background rejection. The shutdown has been also used to implement several other modifications aimed at improving beam dynamics: the wiggler poles have been displaced from the magnet axis in order to cancel high order terms in the field, the feedback systems have been equipped with stronger power supplies and more efficient kickers and electrodes have been inserted inside the wiggler and the dipole vacuum chambers, in the positron ring, to avoid the e-cloud formation. A low level RF feedback has been added to the cavity control in both rings. |
||
| THPE065 | Multipoles Minimization in the DAΦNE Wigglers | 4665 |
|
||
|
The wigglers of the DAΦNE main rings have been one of the main sources of the non-linearities in the collider. A method to minimize the odd integrated multipoles around the beam trajectory (the even ones tend to vanish due to the periodicity of the device) is described. It consists in displacing the magnetic axis of each pole towards the position of the beam in such a way that the integrated odd multipoles are minimized in each half period of the wiggler. After a study, including multipolar and tracking analysis, has performed to determine the best position of the axes, the wigglers in the DAΦNE main rings have been modified accordingly. To validate this approach magnetic measurements and tests with beam by means of closed orbit bumps have been performed. |