• A. Jeff, S. Bart Pedersen, A. Boccardi, E. Bravin, T. Lefèvre, A. Rabiller, F. Roncarolo
  CERN, Geneva
• A.S. Fisher
  SLAC, Menlo Park, California
• C.P. Welsch
  The University of Liverpool, Liverpool

Synchrotron radiation is currently used on LHC for beam imaging and for monitoring the proton population in the 3 microsecond abort gap. In addition to these existing detectors, a study has been initiated to provide longitudinal density profiles of the LHC beams with a high dynamic range and a 50ps time resolution. This would allow for the precise measurement both of the bunch shape and the number of particles in the bunch tail or drifting into ghost bunches. A solution is proposed based on counting synchrotron light photons with two fast avalanche photo‐diodes (APD) operated in Geiger mode. One is free‐running but heavily attenuated and can be used to measure the core of the bunch. The other is much more sensitive, for the measurement of the bunch tails, but must be gated off during the passage of the core of the bunch to prevent the detector from saturating. An algorithm is then applied to combine the two measurements and correct for the detector dead time, after pulsing and pile‐up effects. Initial results from laboratory testing of this system are described in this paper.

• T. Lefèvre, E. Bravin, G. Burtin, A. Guerrero, A. Jeff, A. Rabiller, F. Roncarolo
  CERN, Geneva
• A.S. Fisher
  SLAC, Menlo Park, California

On the Large Hadron Collider (LHC), the continuous monitoring of the transverse sizes of the beams relies on the use of synchrotron radiation and intensified video cameras. Depending on the beam energy different synchrotron light sources must be used. A dedicated superconducting undulator has been built for low beam energies (450 GeV to 3 TeV), while edge and centre radiation from a beam separation dipole magnet are used respectively for intermediate and high energies (up to 7 TeV). The emitted visible photons are collected using a retractable mirror, which sends the light into an optical system adapted for acquisition using intensified CCD cameras. This paper presents the performance of the imaging system in terms of spatial resolution, and comments on the light intensity obtained and the cross calibration performed with the wire scanners. Upgrades and future plans are also discussed.

• A.E. Dabrowski, S. Bettoni, E. Bravin, R. Corsini, S. Döbert, T. Lefèvre, A. Rabiller, P.K. Skowronski, L. Søby, F. Tecker
  CERN, Geneva
• D. Egger
  EPFL, Lausanne
• A. Ferrari
  Uppsala University, Uppsala
• C.P. Welsch
  The University of Liverpool, Liverpool

The CTF3 facility is being built and commissioned by an international collaboration in order to test the feasibility of the proposed CLIC drive beam generation scheme. Central to this scheme is the use of RF deflectors to inject bunches into a Delay Loop and a Combiner Ring, in order to transform the initial bunch spacing of 1.5 GHz from the linac to a final bunch spacing of 12 GHz. The optimization procedure relies on several steps. The active length of each ring is carefully adjusted to within a few millimeters accuracy using a two‐period undulator. The transverse optics of the machine must be set-up in a way so as to ensure the beam isochronicity. Diagnostics based on optical streak cameras and RF power measurements have been designed to measure the longitudinal behaviour of the beam during the combination. This paper presents their performance and highlights recent measurements.