Paper | Title | Page |
---|---|---|
TUOARA03 | Characterization of the THz Source at SPARC | 1296 |
|
||
The region of the spectrum from 0.3 to 5 THz is of great interest for several experiments in different areas of research. A THz radiation source can be produced at SPARC as coherent transition radiation emitted by either a compressed or longitudinally modulated beam intercepting a metal foil placed at 45° with respect to the beam propagation. Results on the characterization of the THz source at SPARC are described in the paper. |
||
|
||
TUPE082 | Advanced Beam Dynamics Experiments with the SPARC High Brightness Photoinjector | 2311 |
|
||
The primary goal of the SPARC project is the commissioning of the SASE FEL operating at 500 nm driven by a 150-200 MeV high brightness photoinjector. Additional experiments are foreseen also in the HHG Seeded configuration at 266, 160 and 114 nm. A second beam line hosting a THz source has been recently commissioned. The recent successful operation of the SPARC injector in the Velocity Bunching (VB) mode has opened new perspectives to conduct advanced beam dynamics experiments with ultra-short electron pulses able to extend the THz spectrum and to drive the FEL in the SASE Single Spike mode. Moreover a new technique called Laser Comb, able to generate a train of short pulses with high repetition rate, as the one required to drive coherent plasma wake field excitation, has been tested in the VB configuration. The energy/density modulation produced by an infrared laser pulse interacting with the electron beam near the cathode has been also investigated. In this paper we report the experimental results obtained so far and the comparison with simulations. |
||
THPEA006 | Beam Energy Upgrade of the Frascati FEL LINAC with a C-band RF System | 3682 |
|
||
In the frame of the SPARC-X project, the energy of the Photo-Injector SPARC, in operation at INFN-LNF, will be upgraded from 180 to 250 MeV by replacing a low gradient S-band traveling wave accelerating section with two C-band units, designed and developed at LNF. The new system will consist of a 50 MW klystron, supplied by a pulsed modulator, to feed the high gradient C-band structures through a RF pulse compressor. This paper deals with the design of the full system, the C-band R&D activity and study of the related beam dynamics. |
||
MOPD098 | Fast IR Array Detector for Transverse Beam Diagnostics at DAΦNE | 936 |
|
||
At the LNF of INFN an IR array detector with a ns response time has been built and assembled in order to collect the IR image of the e-/e+ sources at DAΦNE. Such detector is made by 32 bilinear pixels with a pixel size of 50x50 μm2 and a response time of 1 ns. The device with its electronic board has been assembled for the installation on the e+ ring of DAΦNE in the framework of an experiment funded by the INFN Vth Committee dedicated to beam diagnostics. A preliminary characterization of few pixels of the array and of the electronics has been carried out at the IR beamline SINBAD at DAΦNE. In particular the detection of the IR source of the e- beam has been observed using four pixels of the array acquiring signals simultaneously with a 4 channels scope at 1GHz and at 4 Gsamples/s. The acquisition of 4 pixels allowed monitoring in real time differences in the bunch signals in the vertical direction. Preliminary analysis of data is presented and discussed. In particular we will outline how the differences in the signals can be correlated to small displacements of the source after the bunch refilling and during a complete shift of DAΦNE and before the refilling of electrons. |